Wooden 3 clock dashboard, with carbon fibre finish.

Complete car set of roof lining rods, comprising of 1 Red, 2 White, 1 Black, 1 Blue and 1 Yellow

number 1 with red ends is EEB100060

number 2 and 3 is white ends are both EEB100070

number 4 with black ends is EEB100080
...

Wooden 3 clock dashboard, with carbon fibre finish.

Printed circuit board for pre 1989 cars with Smith's type 3 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.

Wooden 3 clock dashboard, with carbon fibre finish for LHD cars.

Metal plate switch carrier for 5 square type switches.

Original Autin emblem stick on logo for use on gearlever knobs and key fobs sold by us. About 27.4mm wide.

MK1/2 style pattern door and rear quarter black vinyl trim kit for MK3 on

These are the 4 major parts that can give your car a fresh look- only fits wind up window type doors as fitted to MK3 range mid 1973 on , without ash tray facility in...

Metal chromed old type classic handle revived for use on MG variants and then a fashion item on minis. On later cars CMZ312 screw might be required which has a smaller diameter head and longer thread. Length 90mm.

Seal for door handles MK1/2 and all sliding window exterior hinge cars.

also used on 14A7195 mk1 boot handlle used on mk1/mk2 and van/estate



is oval shaped



for boot / rear door use the hole at the rear ...

Chromed version of the standard demist vent on early cars where the ashtray is

mounted in the top and middle of the metal facia. Not for later cars with large

padded windscreen rails and ashtray in the front such as Mini Clubman and...