HEADLAMP MOUNTING RING (PART OF FRONT WING)
14A6693

£15.00 exc vat

£18.00 inc vat

In stockIn stock
This panel is available separately but is fitted on all mini wings. It is required quite often however when fitting a new wing on the ADO16 old 1100 and 1300 cars

£15.00 exc vat

£18.00 inc vat

In stockIn stock

Recommended usage 1 x 14A6693 to fit one mini.
Saloon and Front Ends - Qty 1

People also bought products

A post and inner wing repair panel 8" wide for Mk1/2 saloon and MK1 Van/pickup

R/H side--6" from a post section

A post and inner wing repair panel 8" wide for Mk1/2 saloon and MK1 Van/pickup

L/H side-6" from A post section

O/S/F wing t for 1996 on cars. THIS WING STILL NEEDS MODIFYING to allow for fitting of Sportspac arches and 13" wheels. After trimming/cutting to size remember to replace or renew the stiffener lip ALR360380

Has the headlamp re...

Part inner wing L/H from Damper bracket mounting points forward. MK1/2/3 except Clubman. This panel has radiator cooling slats as fitted to 1991

NON genuine panel only as part panel

part inner wing R/H from Damper bracket mounting points forward MK2/3 except Clubman. 1969-91 not Mk1/2 as it has air hole in side

NON genuine panel

If you fit 13" wheels and need to cut the wings away for clearance these are the reinforcements strips Rover used on the cars with Sportspack arches.

see Downloads on web site for diagrams on where to cut wings and A panels under part number...

Aftermarket wings do the job at a fraction of the cost of originals. This right front wing for the Mini will fit all MKI, II, III, IV. A slight difference exists between the early and the later models as to headlamp mounting holes. These reproduction...

Only this genuine wing is now available for the mini clubman but you will probably require the headlamp backing panel CZH120

Only this genuine wing is now available for the mini clubman but you will probably require the headlamp backing panel CZH121

1970 on, cars with internal hinges and wind up windows

This repair panel has holes for the hinges on A post and overlaps 3.5"(85mm)onto the wheel arch section of inner wing

1970 on, cars with internal hinges and wind up windows

This repair panel has holes for the hinges on A post and overlaps 3.5"(85mm)onto the wheel arch section

1970 on, cars with internal hinges and wind up windows

This repair R/H panel has holes for the hinges on A post and overlaps 6" at top tapering to 9" at bottom (150mm-215mm) onto the wheel arch section.

Also has the first section of...

1970 on, cars with internal hinges and wind up windows.

This L/H repair panel has holes for the hinges on A post and overlaps 6" at top tapering to 9" at bottom (150mm-215mm)onto the wheel arch section.

Also has the first section of...

Aftermarket wings do the job at a fraction of the cost of the originals. This left front wing for the Mini will fit all MKI, II, III & IV. A slight difference exits between the early and the later models as to headlamp mounting holes. These reproduct...

These wings have the original round headlamp hole which is okay unless you have the dipping headlamps fitted to some export models and MPI cars--

1997-2000 cars need to use ASB360009 which has the recess for the headlamp adjusti...

Fits all minis with side repeater lamps and an aerial hole from 1988 until 1996 except export models with adjusting headlamps. After 1997 ASB360010 should be used, which has no aerial hole, and a recess for the dipping headlight motor. ...

Fits all minis with side repeater lamp from 1988 up until 1996 except export models with adjusting headlamps.

1997-2000 cars need to use ASB360009 which has the recess for the headlamp adjusting motor. cars registered after 1st...

Minis most used rubber plug 1.25" wide for holes approximately 7/8".

Fits floor, aerial hole and steering column extra hole and radius arm shroud on MK1/2 minis.These floor plugs vary in number from 11 in a Elf/Hornet,Mk1 and 1994 on cars do...

N/S/F wing without ariel hole which was standard fiment for 1996 on cars which had a factory fitted roof ariel. THIS WING STILL NEEDS MODIFYING to allow for fitting of Sportspac arches and 13" wheels. After trimming/cutting to size remember to replac...

The Heritage produced front wings (fenders) for the Mini are the original with

correct round hole for headlamp. They fit. The proper gauge metal and original tooling ensures that even the novice body man can make them work great. Cars regist...