£175.39 exc vat
£210.47 inc vat
In stock
General:
Many years of research and development have been spent on what on the surface is only a necessary evil! Getting the exhaust out of the engine would seem simple enough but modern technology and manufacturing has made it a real science. The LCB (Long Center Branch) header (exhaust manifold) has been developed to the point that an actual improvement in performance can be achieved by its use.
They not only fit well and add performance but also are long lasting!
Ease of fitting and high production quality combined with maximum flow for power make the exhaust manifolds (tubular steel headers) an unbeatable value. Special attention is paid to all joints and welds to obtain required backpressure and exhaust gas flow.
See C-AHT12 for exhaust pipe "system".
See C-AHT11/LCB/BIGBORE for large bore LCB.
£175.39 exc vat
£210.47 inc vat
In stockRecommended usage 1 x C-AHT11 to fit one mini.
Standard bore road LCB (1-3/4"id) that has an enlarged and reshaped middle pipe which creates a type of vortex, simulating a pulsing effect similar to the outside two pipes,thus producing an improved BHP,Torque and power curve.Ideal for very hot smal...
Special reinforced gasket for injection cars has metal inserts on exhaust ports plus a metal back on the manifold side which makes surface easier to clean when replacing. Often used on Turbo cars when correct gasket is in short supply.
...
Manifold gasket fitted to all A series pre 1992 except Turbo which had a reinforced exhaust ports GUG704063MG and SPI from 199. From 1991 on a new better gasket with reinforced exhaust ports and backing was fitted GUG704053MG
Manifold stud for all A series injection engines and some late carburettor cars which is 45mm long-6mm longer than 53K487.carburettor engines usually retained the 53K487 shorter screw for the outside 2 holes.
Sold singly,6 per c...
Aftermarket union for fitting all mini inlet manifolds where a take off is required for your brake servo or emission valve on Cooper S cars.
Locating rings originally made for 12G295 heads with twin carbs to line up the inlet manifold to the inlet ports on the cylinder head it found its way on most twin carb factory produced cars. There is a recess in the inlet port on the he...
Mini Spares genuine RC40 system has justifiably earned the reputation of the best exhaust ever made for the Mini. Mild steel with stainless steel tailpipe. Typically used with an LCB manifold it gives great performance with a mellow soun...
This is for 1.8750" bore side exit when there is no catalyst
See C-ARA338 also
Complete mounting kit for the RC40 exhaust. Includes all new rubber mounts, brackets and clamps.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.