£14.00 exc vat
£16.80 inc vat
In stock
made for negative earth only--BR1310
£14.00 exc vat
£16.80 inc vat
In stockRecommended usage 1 x C34770A to fit one mini.
Starter solenoid bracket that bolts to the flywheel housing on MK1/2 cars. For Cooper S see 12A326.
Wiper motor fitting kit to fit all mk2 onwards wiper motors to the bulkhead.
Wiper motor kit for all mk2 onwards cars, includes wiper motor, motor gear, wheel boxes, outer tube kit, wiper rack and wiper motor ferrule.
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
Interior lamp with a black on/off switch and pointed torpedo ends.
Also fitted many of the 1959on range of Austin A55/60 Cambridge, MG Magnette etc.
Also there was an alternative lamp with black switch and square ends 13H192 which w...
This is the wiring required if you have side repeater lamps on your front wings including bulb holder, grommet and connectors LESS the bulb. The large grommet that sits in the inner wing where the wires go through is YML10654. sold indiv...
Battery bar and fitting kit for all post 1990 cars whcih had the longer battery bolts.
Battery bar and fitting kit for all pre 1990 cars whcih had the shorter battery bolts.
Original style oil temp gauge as fitted to MPI Minis from 1996 onwards.
Reverse lamp as used on some Mokes/kit cars etc, essentially the same as our indicator lamp CHM13WHITE but with a clear single filament bulb rather than orange and white plastic lens.
Dip switch lead for right hand drives cars, these are not included with new looms.
Mini Mk 4 998 oval centre dash,twin column stalks,rocker switches including rear fog and heated rear window,reverse lights and rear fog lamp is on headlamp circuit. Intertia starter. To go with AN145 rear loom.
mainly for 1980-1...
This will replace the orange lens fitted on the wing of all cars from 1986 on, fitted with an orange LED. If you need a new loom for this lamp see AFU3358. Sold singly. Does not require a resistor.
Genuine Bosch lambda sensor, fitted to both the twin and single point injection cars and fitted in the same exhaust manifold shared by both cars. Be warned the cheaper non branded sensors cause lots of issues hence we only sell the Bosch version.
Electric water gauge as standard on the centre binnacle Mini. Marked 50-90-140°C Genuine Smiths. With a magnolia face.
Electronic ignition conversion. For points type distributors, fixed or sliding. Negative earth only. Also, available for earlier 23/25D on Negative earth (LU142) or earlier 23/25D with Positive earth (LU142AP12).
ONLY use GCL217 coil for bal...
Smiths Electric oil pressure gauge in Magnolia.
Sender PTR1810-1-10 required.
Also known as the idle air control valve (IACV). Bolts on the side of the injection body housing to control engine idle speed and air flow from cold start up. The blue socket loom cap fits this unit. This is part of MLZ100090. After fitt...
Braided Wiring loom for MK1, floor starter with coil on dynamo and temp gauge. 1962-63 approx. 3 clock type
This unit fits directly on to the gearbox in place of the standard cable and produces a digital signal for use with an electronic speedometer requiring a 5 volt square wave pulse such as our electronic speedo 13H4443. For pre 1980 speedo...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.