£3.00 exc vat
£3.60 inc vat
Out of stock
£3.00 exc vat
£3.60 inc vat
Out of stock
Used on all MK1/2/3 bootlids there are 26 little holes drilled around the inner edge to hold the seal on and this kit contains the 26 clips. For single clips see 14A6585. Later cars 1988 on fitted a seal to the body only. (CKE10018)
Moulded shape type right hand door stay grommet fitted until 1985 when it was replaced by a flat sponge type seal CGE10038/9.
Rubber seal for all mini windshields. Uses locking strip 24A1466(chrome) or 37H8052(black.) REMEMBER YOU MUST FIT THE RUBBER TO THE BODY FIRST. DO NOT USE THE STRING METHOD BECAUSE IT STRETCHES AND TEARS THE RUBBER.
There is a later wider r...
Fitted to inner wing 1990 on, plus on a bracket on the rear wheel arch in boot area for all single points onwards. For earlier cars where fitted on the bulk head you may need to put a spacer behind to make removal of bottle easier.
Original ...
Moulded shape type left hand door stay grommet fitted until 1985 when it was replaced by a flat sponge type seal CGE10038/9.
Quality Aftermarket Body Seam Covers. These are the vertical ones that protect the 4 corners of your cars body seams. Both original and Mini Spares own aftermarket strips are available plus a stainless steel version for that special Mini.
These gaskets should be changed when replacing the hinges, this one goes between the bootlid hinge on the body, see 24A2175 also for upper on bootlid.
These gaskets should be changed when replacing the hinges-this one goes between the bootlid hinge on the bootlid. See also 24A2176 for gasket on body.
Finishing clip in brightwork (chrome colour)for 24A1466MS locking strip in windscreen and backlight rubbers.
Correct size self tapper screw for 24A88 lower sliding window channel when door holes have not rusted out to larger size.
Clear plastic windscreen washer tubing sold by the metre only. This is the larger size and was known as 1/4" bore because GWW201M is 1/8" bore. This hose is actually now known as 4.8mm which is nearer 3/16".
this was known as 1/...
Zinc plated mild steel clip for fixing vertical seam mouldings to the body.
The plastic chrome insert for fitting in the windscreen and backlight rubbers of all minis. You will require TOOL02 to fit these.
Seal for glass that fits both rear doors on vans/estates. The reason for changing these every few years is that if they leak the water runs into the doors causing excessive rust.
The pin that goes into the door stay check arm on the door itself on all minis with wind up type windows from 1970 to 2000.
Genuine door check strap for MK3 cars with wind up window doors.(use with retaining pin CLZ412 ). Beware! there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.