Countersunk, crosshead screw. 1/4"unf 19mm (3/4") total length.

This screw fits the internal door hinges on wind up window cars and the striker plate on the B post.

Door hinge shim for all wind up window cars, these are used to align the doors, 1.2mm thick and made in stainless steel use, with ALA6383 to get good door alignment See ALA6381 for thicker rear support plate.

Also se kits MSSK017 and MSSK017B

Genuine lower hinge--note, the 2 studs actually thread into the genuine hinge so can be replaced if damaged or broken

4 Non Genuine door hinges as a car set for wind up window type doors from 1970 on. These are a top quality item as opposed to the cheaper junk version available on the market.

Sold seperately as

top right CZH202MS 1 r...

High quality non genuine door check strap for MK3 cars with wind up window doors (use with retaining pin CLZ412). Beware there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly!

Complete fitting kit for the door check straps on all Minis fitted with external hinges.

Stainless steel version of CZG5254 door striker plate. These used to be sided on earlier models but now fit either side. CZH627 striker plate lock with a loop fits into this. Supplied in pairs with stainless steel fixing scr...

MK3 door hinge fitting kit for all internal hinged doors. (hinges not included)

Special thread cutting screw 1/4 UNF 1.25" (31mm) long.

Screw to hold the lock assembly on the door of MK3 cars with internal hinges and wind up windows. On new doors or for easy fitment use these special screws with cutting thread (3 sided ...

This screw can used to hold together the 2 halves of the disc shields on all

mini front discs. fits MK1/2 door escutcheons.

Use SE910161 and cut down to 3/8" long including head

PMZ306 was originally 3/8"long u...

Twin point injection cars had a split seal system door frame seal for the front doors,the lower acting as a shield cover for the trim, fitted from chassis no BD134455 ON

Some customers have replaced it by the one piece CGA2835MS<...

The rubber that sits in the frame to hold the windows on wind up window type doors. The frames are ALA5746/7 or see MSSK2105 also used on Clubman Estate and Traveller rear windows in the finger pull grips.

Sold individually.2 pe...

upper door hinge l/h for wind up window type door with internal hinge 1970on

this is not a genuine part and is available in a car set kit MSSK017B

See CZH203 for genuine

Genuine Mini Spares mouldings product as supplied to Rover.

These are the later door mouldings that prevent water running down the windows into the door causing rust and have the black platic ends fitted for later car safety regulations but ...