Genuine Mini Spares UK made complete joint with the following specifications,

correct dimensions and shape of pin and ball in EN24T, using correct spec grease,

genuine original shape cup using correct material (21A423MS...

This kit contains all the parts from MS44 plus the 4 cast trunnions that hold the rubber bushes. This complete rear subframe fitting kit is what the factory fitted to minis up to 1976 on but the later kit MS41 will fit early...

This is the metal packing piece for the twin bolt pre 76 front dry subframe tower mount.

Plastic sleeve for protecting hydrolastic pipe - held in place by 21A1757 on rear; 21A1487 on front. Sold singly and 4 required per car.

Plastic plug suplied in rear strut kit for HILO's.

Tie rod extra hard rubber bush, harder than standard.

You dont want these bushes too hard as it can cause the threaded on the end of the tie rod to break under extreme conditions.

In theory the outer ones should be harder for rigidi...

Adjustable tie-rod kit with C-STR627 rubber bushes and all bolts,nuts and washers required. This is one car set.

When you change the length of the lower control arm to attain the desired degree of camber, the caster also change...

Ultimate road or race geometry kit which includes following parts. Adjustable tie rods and lower arms with the correct bush kits. For the rear a set of camber and tracking brackets. When fitted the suspension must be properly set up. This kit will dr...

Angled grease nipple for the upper arm on the front suspension of all Minis

importantly lubricates the upper arm spindle which so often gets neglected so check yours out and make sure this nipple is working properly. Also fits rear radius ar...

Complete rebuild kit for rear radius arm as sold by us since 2005.

Beware of cheap imports that are available in the market as they do not have correct heat treatment where required and have no longevity.

Kit Includes: shaft, beari...