£121.25 exc vat
£145.50 inc vat
Special order
You'd think that the way Min...
£121.25 exc vat
£145.50 inc vat
Special orderRecommended usage 1 x GB5014 to fit one mini.
This Genuine AP 3 way connector was used on the diagonal split braking system joining the front brake pipes to the main line system on both sides of the car, hence 2 fitted. On later dual line cars, with the pressure valve on the bulkhead (1978 on), ...
We all believe that our life often depends on our braking system. But how can you tell when "it's good enough"? The flexible rubber brake hoses are a prime area for concern. The hose is both exposed to road grime (rain and dirt) but it is also expose...
Rear Braided brake hose set, with banjo union bolts and howver you need some tie wraps to hold hose to arms, runs from Radius Arm to Rear Cylinder, replaces both standard metal and rubber hose. No modifications are required and is of special interest...
Genuine Lockheed seal rebuild kit for Cooper S brake calipers. One kit needed per caliper. When it comes to safety critical parts, only fit the original suppliers' parts as repair kits. The kit includes all the seals needed to do both pistons in one ...
Gasket used under the dual master cylinder brake master cylinder. For the earlier single line brake pipe system see 31G279.
originally fitted to the 1275GT 1976/7 single line system plus NON UK 850/998 diagonal split systems for the same years --half inch bore size it was the smallest cylinder ever used--repair kit was BHM7015 which is now very scarce.Uses [l...
This special shake proof washer should be replaced. Found on front hose.
Also used on 21A1524 hydrolastic pipe adaptor.
Genuine AP product as original.This strange looking coily spring holds the front brake shoes against the drum for better braking efficiency by holding them in a set position which also cuts out brake judder caused by sideways movement.
Fitte...
Twin leading shoe brakes use two wheel cylinders per wheel, but you buy them singly. These cylinders are the 15/16" diameter style that will fit MK1/2/3 models 1964 on with .9375" bore size with 1 1/2" shoes.
Sold with bleed nipple but requi...
If you have original drum brakes on the front of your mini with twin leading shoes (2 cylinders per drum) this is the kit of 4 tension springs you should change. Originally a double spring type they are now single spring coil per item but more effici...
Twin leading shoe brakes use two wheel cylinders per wheel, but you buy them singly. These cylinders are the 15/16" (.9375") diameter style that will fit MK1/2/3 models 1964 on with 1 1/2" shoes.
Sold with bleed nipple but require[link]37H38...
This is the repair kit for GMC167. This square plastic canister (reservoir) type brake master cylinder had separate circuits for diagonal split brakes; it's recognised by the rectangular reservoir and small cap with a failure switch on t...
Gasket between backplate and front wheel cylinders on cars with 2 cylinders per wheel.
Genuine R/H original AP backplate. If the brake adjusters on your front twin-leading brakes have seized up, there is no real repair short of replacing this backplate! For minis from MK2 on - 1968 to 1984 - this is a safety critical part and therefore...
Genuine L/H original AP backplate. If the brake adjusters on your front twin-leading brakes have seized up, there is no real repair short of replacing this backplate! For minis from 1968-1984.
This is a safety critical part and therefore onl...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.