£41.04 exc vat
£49.25 inc vat
In stock
initiates idle speed control via the idle air valve control MLZ100090 (check MLZ100090 for cracks or damage as this part is suspect when involved in accidents).
£41.04 exc vat
£49.25 inc vat
In stockRecommended usage 1 x SLD100080 to fit one mini.
Also known as the idle air control valve (IACV). Bolts on the side of the injection body housing to control engine idle speed and air flow from cold start up. The blue socket loom cap fits this unit. This is part of MLZ100090. After fitt...
Bolts on the side of the injection body housing to control engine idle speed and air flow from cold start up. The blue socket loom cap fits this unit. This is part of MLZ100090. After fitting the cars ignition needs to be turned on and o...
Genuine Mini Spares product. The seal that goes on the neck of petrol tanks as protection against water intrusion and to also to make the hole look neater, so replace them when they crack or shrink through heat. This is the original fatter type as us...
Basic idle air control valve for spi Mini's. Unlike the mpi stepper motor which uses a bypass valve this unit controls the throttle directly, if you are having issues on idle then 1 or more of the 4 windings could not be working, this is usually due ...
The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank out before fitting and drive your mini more to avoid water build up.
Replacement pump only for the original WFX100810<...
The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank before fitting and drive your mini more to avoid water build up.
Replacement pump only for the WFX100810 (doesn't...
Description
An "ALL IN ONE" fuel treatment providing ethanol protection, lead replacement and an octane improver that adds up to two octane numbers (20 points) to unleaded fuel.
Endorsed by FHBVC to protect against the corros...
THE ELECTRICAL CIRCUIT FOR THE FUEL PUMP INCORPERATES AN INERTIA FUEL SHUT OFF(ifs) SWITH WHICH WILL STOP FUEL BEING DELIVERED TO THE ENGINE IN THE EVENT OF SUDDEN DECELERATION--It is fitted in the engine compartment, fixed to the bonnet switch brack...
Gasket/seal for mounting the fuel pump to tank for SPI and MPI Mini's
USE MDQ100040MSAlso known as the idle air control valve (IACV). Bolts on the side of the injection body housing to control engine idle speed and air flow from cold start up. The blue socket loom cap fits this unit. This is part of [link]...
Seal to fit between union WKB10019 and the fuel filter on injection cars.
complete rebuild kit for Turbo type HIF44 carbs including needle valve and throttle spindle plus disc.With damper clamp ring as fitted to turbo only
These were special screws which should be changed when used as they have a securing area on them to stop vibrating loose, as they are no longer available we have had a replacement screw made
There are 4 vacuum pipes on the single point injection car. This one fits to the underside of the air box to back of inlet manifold.
MLH10022 Which has angled ends,fitted from inlet manifold to fuel trap.
[link] M...
Vacuum pipe that fits to the air inlet pipe on all SPI Models
(Air box underside to air box upperside hot air temperature control valve.)
MLH10022 Which has angled ends,fitted from inlet manifold to...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.