£150.00 exc vat
£180.00 inc vat
In stock
See EDP9317 for the gasket/seal to tank. If you are mechanically minded see WFX100811 pump only which is half the price.
The main cause of failure is water in the pump. This is caused by modern ethanol fuel so clean the tank out before fitting and drive your mini more to avoid water build up.
ORIGINALLY FOR THE TWIN POINT ONLY FROM 1996 ON AND IS INDENTIFIED BY THE NUMBER ON THE PUMP ITSELF. THE FOLLOWING NUMBERS HELP IN IDENTIFYING WHICH PUMP YOU HAVE:
SINGLE POINT- 03921 6443434 (USUALLY WITH A GREEN CAP)
MULTI POINT- 2517 6550 09601.
£150.00 exc vat
£180.00 inc vat
In stockRecommended usage 1 x WFX100810 to fit one mini.
Gasket/seal for mounting the fuel pump to tank for SPI and MPI Mini's
The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank before fitting and drive your mini more to avoid water build up.
Replacement pump only for the WFX100810 (doesn't...
The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank out before fitting and drive your mini more to avoid water build up.
Replacement pump only for the original WFX100810<...
Complete kit for fitting an MPI tank, including tank, pump, sender and seals.
The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank out before fitting and drive your mini more to avoid water build up.
Replacement pump only for the original WFX100810<...
The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank before fitting and drive your mini more to avoid water build up.
Replacement pump only for the WFX100810 (doesn't...
Mini Spares Non Genuine version mechanical fuel pump. Brilliant aftermarket alternative for cars pre 1990.
Drives off the camshaft at the rear of the motor. These pumps are generally reliable but when a diaphragm goes bad it can be very bad ...
Non Genuine metal bodied electric fuel pump with metal banjo pipe ends for long life,with blue plastic end. Ethanol tolerant and resistant internals.
This is a cheaper alternatives for the original SU pumps, different to look at and fit but ...
THE ELECTRICAL CIRCUIT FOR THE FUEL PUMP INCORPERATES AN INERTIA FUEL SHUT OFF(ifs) SWITH WHICH WILL STOP FUEL BEING DELIVERED TO THE ENGINE IN THE EVENT OF SUDDEN DECELERATION--It is fitted in the engine compartment, fixed to the bonnet switch brack...
Gasket/seal for mounting the fuel pump to tank for SPI and MPI Mini's
Fuel pipe from the fuel filter to engine on spi and mpi models up to chassis no WD169574 when fuel filter GFE7059is fitted.
Tube nut has four threads, the metal pipe has a union on the end that is fatter than the metal...
The 1990-1 models of the Mini with 1275cc engines and HIF44 carbs use this different mechanical fuel pump. Driven off the camshaft at the rear of the motor these pumps are generally reliable but when a diaphragm goes bad it can be very serious as oft...
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
This is...
Special rubber hose 1/4" bore for use on petrol lines, this is in black and not armour plated outside but does have internal reinforcing. Supplied as pre cut 1m length with 2 clips and is safe to use with modern fuels with higher ethanol content. SAE...
Used on Facet range of solid state and silver fuel pumps SS501/2/3 with 1/8" nptf thread size with 1/4" standard fuel line.
named after its shape thesre are 2 of these on plastic outlet covers on every SU electric pump and the gasket underneath them is AUB676
the round gasket that sits under the AUB663 plastic outlet banjos on every Electric SU pump
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps.
If you need the 5/16...
If you have a mechanical fuel pump fitted to your engine this spacer block fits between it and the engine. The gaskets are available seperately however as GUG705779GM.
Paper gasket for either side of the spacer on all mechanical fuel pumps fitted on the rear of engines. The spacer with gaskets fitted is available as GUG705603GM.
Mechanical fuel pump, pre1990 driven off the camshaft at the rear of the motor. These pumps are generally reliable but when a diaphragm goes bad it can be very bad as often raw fuel is pumped into the engine. This dilutes the oil and causes severe we...
A genuine original S.U. pump ETHANOL tolerant since 2011/2 that will fit into your original mountings with no hassle. Suitable for all cars with electric "pusher" pumps. Replacement points for this are available as AUB6106A.
An...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.