ELECTRIC SU FUEL PUMP
AUF214

£127.76 exc vat

£153.31 inc vat

In stockIn stock
A genuine original S.U. pump ETHANOL tolerant since 2011/2 that will fit into your original mountings with no hassle. Suitable for all cars with electric "pusher" pumps. Replacement points for this are available as AUB6106A.

An alternative shorter plastic body type is available as AUF214MS which has proven very popular for customers not worried about originality with price in mind.

The rubber strap to fit the genuine pump snugly in the bracket is ACB9252.

The clamp bracket to hold the pump is 21A632.

the bracket that holds the clamp bracket to the subframe is 21A750.

Repalcement ethanol tolerant diaphragm is available as AUB6097 for older pumps built pre 1993

£127.76 exc vat

£153.31 inc vat

In stockIn stock

Recommended usage 1 x AUF214 to fit one mini.
Fuel Pumps & Petrol Pipe - Qty 1

Recommended products

Clamp for the electric SU petrol pump which is fitted on the rear subframe. The bracket that holds this with castellated nuts for ease of fittng is 21A750.

This clamp should have a sponge pad (ACB9252) to protect an...

Bracket for SU pump clamp that bolts on the rear subframe.

The clamp that fits this to actually hold the pump is 21A632.

Electric SU pump is AUF214

Rubber strap to hold pump in bracket is [link]...

Special clip for all our braided s/steel petrol hoses.14mm to 16mm.

Special rubber hose 1/4" bore for use on petrol lines, this is in black and not armour plated outside but does have internal reinforcing. Supplied as pre cut 1m length with 2 clips and is safe to use with modern fuels with higher ethanol content. SAE...

Fuel pump buffer sponge for the SU electric pump

Alternative products

Non Genuine metal bodied electric fuel pump with metal banjo pipe ends for long life,with blue plastic end. Ethanol tolerant and resistant internals.

This is a cheaper alternatives for the original SU pumps, different to look at and fit but ...

People also bought products

The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank out before fitting and drive your mini more to avoid water build up.

Replacement pump only for the original WFX100810<...

The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank before fitting and drive your mini more to avoid water build up.

Replacement pump only for the WFX100810 (doesn't...

Mini Spares Non Genuine version mechanical fuel pump. Brilliant aftermarket alternative for cars pre 1990.

Drives off the camshaft at the rear of the motor. These pumps are generally reliable but when a diaphragm goes bad it can be very bad ...

Non Genuine metal bodied electric fuel pump with metal banjo pipe ends for long life,with blue plastic end. Ethanol tolerant and resistant internals.

This is a cheaper alternatives for the original SU pumps, different to look at and fit but ...

For 1275cc engines after 1990 on with HIF38 carbs.

has a 5/16" (8mm)inlet which makes it unique to this model

The 1990-1 models of the Mini with 1275cc engines and HIF44 carbs use a AZX1817 mechanical fuel pump. Driven ...

Gasket/seal for mounting the fuel pump to tank for SPI and MPI Mini's

Fuel pipe from the fuel filter to engine on spi and mpi models up to chassis no WD169574 when fuel filter GFE7059is fitted.



Tube nut has four threads, the metal pipe has a union on the end that is fatter than the metal...

The 1990-1 models of the Mini with 1275cc engines and HIF44 carbs use this different mechanical fuel pump. Driven off the camshaft at the rear of the motor these pumps are generally reliable but when a diaphragm goes bad it can be very serious as oft...

For use on the red top facet fuel pump that uses 5/16" fuel lines and 1/4 nptf threads.

Points for the original style AUF214 SU electric fuel pump,if the car has not been used for a while these points often stick so you need to give the pump a few careful whacks to help them disengage. If they stick again check them over f...

Made for the facet solid state range of pumps (SS501/SS502/SS503) this pre filter with screw in union must be used to eliminate fuel tank debris damaging either the filter or carb/engine etc.

Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.

This is...

Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.

Orange ...

Special rubber hose 1/4" bore for use on petrol lines, this is in black and not armour plated outside but does have internal reinforcing. Supplied as pre cut 1m length with 2 clips and is safe to use with modern fuels with higher ethanol content. SAE...

This solid state electrics kit fits your standard pump to eradicate those old stcky points system that let down an otherwise good pump. these fit the AUF214

original electric fuel pump. for positive earth see EPK12P

Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.

Orang...

Silver top competition fuel pump with 5-6 psi -30 gallons per hour,is ideal for high output engines especially using a twin choke carb such as weber/dellorto with choke sizes up to 45mm. Has 1/8"nptf threads for 1/4" fuel line

Original body but with latest solid state electric functions for reliability

see AUF214EP for positive earth type.

Used on Facet range of solid state and silver fuel pumps SS501/2/3 with 1/8" nptf thread size with 1/4" standard fuel line.

named after its shape thesre are 2 of these on plastic outlet covers on every SU electric pump and the gasket underneath them is AUB676