ELECTRONIC FUEL PUMP FACET STANDARD SOLID STATE
SS501

£53.39 exc vat

£64.07 inc vat

In stockIn stock
Ideal replacement for the original mechanical pump this road tune pump delivers 12 gallons of fuel per hour at 2.5-3.00 psi,with 1/8" NPTF thread sizes see unions FPA903. This pump is suitable for single SU carb but see SS502 for further state of tune.

Other parts required to fit this pump are:

FPA905 Rubber Mount Kit x1

FPA906 Pre pump filter union x1

FPA903 Union x1

£53.39 exc vat

£64.07 inc vat

In stockIn stock

Recommended usage 1 x SS501 to fit one mini.

Recommended products

this rubber mounting kit helps to dampen the pump ticking noise as well as acting as an earth

Used on Facet range of solid state and silver fuel pumps SS501/2/3 with 1/8" nptf thread size with 1/4" standard fuel line.

Made for the facet solid state range of pumps (SS501/SS502/SS503) this pre filter with screw in union must be used to eliminate fuel tank debris damaging either the filter or carb/engine etc.

Used on Facet range of solid state and silver fuel pumps SS501/2/3 with 1/8" nptf thread size with 1/4" standard fuel line.

Alternative products

Ideal well priced electric fuel pump for replacing either electric or mechanical pumps when using single HS or HS2 twin carbs 4.00-5.5 PSI delivering 18 gallons per hour.

Other parts required to fit this pump are:

FPA9...

People also bought products

The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank before fitting and drive your mini more to avoid water build up.

Replacement pump only for the WFX100810 (doesn't...

Mini Spares Non Genuine version mechanical fuel pump. Brilliant aftermarket alternative for cars pre 1990.

Drives off the camshaft at the rear of the motor. These pumps are generally reliable but when a diaphragm goes bad it can be very bad ...

THE ELECTRICAL CIRCUIT FOR THE FUEL PUMP INCORPERATES AN INERTIA FUEL SHUT OFF(ifs) SWITH WHICH WILL STOP FUEL BEING DELIVERED TO THE ENGINE IN THE EVENT OF SUDDEN DECELERATION--It is fitted in the engine compartment, fixed to the bonnet switch brack...

Gasket/seal for mounting the fuel pump to tank for SPI and MPI Mini's

The 1990-1 models of the Mini with 1275cc engines and HIF44 carbs use this different mechanical fuel pump. Driven off the camshaft at the rear of the motor these pumps are generally reliable but when a diaphragm goes bad it can be very serious as oft...

For use on the red top facet fuel pump that uses 5/16" fuel lines and 1/4 nptf threads.

Points for the original style AUF214 SU electric fuel pump,if the car has not been used for a while these points often stick so you need to give the pump a few careful whacks to help them disengage. If they stick again check them over f...

Made for the facet solid state range of pumps (SS501/SS502/SS503) this pre filter with screw in union must be used to eliminate fuel tank debris damaging either the filter or carb/engine etc.

Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.

This is...

Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.

Orange ...

Special rubber hose 1/4" bore for use on petrol lines, this is in black and not armour plated outside but does have internal reinforcing. Supplied as pre cut 1m length with 2 clips and is safe to use with modern fuels with higher ethanol content. SAE...

Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.

Orang...

Silver top competition fuel pump with 5-6 psi -30 gallons per hour,is ideal for high output engines especially using a twin choke carb such as weber/dellorto with choke sizes up to 45mm. Has 1/8"nptf threads for 1/4" fuel line

Original body but with latest solid state electric functions for reliability

see AUF214EP for positive earth type.

Used on Facet range of solid state and silver fuel pumps SS501/2/3 with 1/8" nptf thread size with 1/4" standard fuel line.

named after its shape thesre are 2 of these on plastic outlet covers on every SU electric pump and the gasket underneath them is AUB676

For use on the Facet range of solid state fuel pumps.

Only used for STC505 Facet pump range or solid state SS502 & SS503 and silver fuel pumps with 1/8" nptf thread size with 5/16" upgraded fuel line.

Before the days of Aeroquip, the British were making their own braided steel fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. British Length 7.5"...