Genuine Mini Spares product. The seal that goes on the neck of petrol tanks as protection against water intrusion and to also to make the hole look neater, so replace them when they crack or shrink through heat. This is the original fatter type as us...

SPI throttle body spacer - the gaskets are available as LZV1101GASKET

THE ELECTRICAL CIRCUIT FOR THE FUEL PUMP INCORPERATES AN INERTIA FUEL SHUT OFF(ifs) SWITH WHICH WILL STOP FUEL BEING DELIVERED TO THE ENGINE IN THE EVENT OF SUDDEN DECELERATION--It is fitted in the engine compartment, fixed to the bonnet switch brack...

Linkage set for Converting from waxstat to standard type jet for one single carb .

Fuel Injector sealing ring for all MPI Models

These were special screws which should be changed when used as they have a securing area on them to stop vibrating loose, as they are no longer available we have had a replacement screw made

Vacuum pipe that fits to the air inlet pipe on all SPI Models

(Air box underside to air box upperside hot air temperature control valve.)





MLH10022 Which has angled ends,fitted from inlet manifold to...

Fits on throttle body housing

initiates idle speed control via the idle air valve control MLZ100090 (check MLZ100090 for cracks or damage as this part is suspect when involved in accidents).

Universal stud made for fitting the HS4/HIF carb to the manifold (except HS6 with alloy spacer on cast one piece manifold which requires CHS2515 (5.8mm longer)) and it also fits the cylinder head to take the thermostat housi...