£0.50 exc vat
£0.60 inc vat
In stock
£0.50 exc vat
£0.60 inc vat
In stockRecommended usage 2 x LZV1101GASKET to fit one mini.
HEAD GASKET SET FOR SINGLE POINT INJECTION (SPI) FROM 1992 TO 1996. (Throttle body piece not included but gaskets are available as LZV1011GASKET)
The new adjustable height StayUp® Float is resistant to modern ethanol based Fuels and has a military spec closed cell construction making it puncture proof. The ability to adjust the Float Arm allows for quick and easy minor alterations to Float lev...
5/16" UNF THREAD 2 1/2" LONG bolt commonly used for 21A2838 petrol tank strap
Genuine Mini Spares product. The seal that goes on the neck of petrol tanks as protection against water intrusion and to also to make the hole look neater, so replace them when they crack or shrink through heat. This is the original fatter type as us...
Original 7/16" spring type hose clip as used on later cars (approx 1990 on) for some radiator hoses and fuel lines.
The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank out before fitting and drive your mini more to avoid water build up.
Replacement pump only for the original WFX100810<...
5/16" bore petrol hose for injection cars sold in metre lengths.
Resilient to heat,weather and suitable for ethanol in modern day fuels.100psi max.R9 spec.
The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank before fitting and drive your mini more to avoid water build up.
Replacement pump only for the WFX100810 (doesn't...
Fuel pipe from the fuel filter to engine on mpi models from chassis no WD169574 when fuel filter GFE7057 is fitted.
Tube nut has 7 threads and the metal pipe is the same size with a flared end.
SPI throttle body spacer - the gaskets are available as LZV1101GASKET
Mini Spares Non Genuine version mechanical fuel pump. Brilliant aftermarket alternative for cars pre 1990.
Drives off the camshaft at the rear of the motor. These pumps are generally reliable but when a diaphragm goes bad it can be very bad ...
This is the small plastic nut used to hold the fuel line protector shield on later cars, also used to hold the catalytic converter heat shield on, 4 required for each shield.
THE ELECTRICAL CIRCUIT FOR THE FUEL PUMP INCORPERATES AN INERTIA FUEL SHUT OFF(ifs) SWITH WHICH WILL STOP FUEL BEING DELIVERED TO THE ENGINE IN THE EVENT OF SUDDEN DECELERATION--It is fitted in the engine compartment, fixed to the bonnet switch brack...
For 1275cc engines after 1990 on with HIF38 carbs.
has a 5/16" (8mm)inlet which makes it unique to this model
The 1990-1 models of the Mini with 1275cc engines and HIF44 carbs use a AZX1817 mechanical fuel pump. Driven ...
Gasket/seal for mounting the fuel pump to tank for SPI and MPI Mini's
If you've ever changed a fuel filter on an injection car you may have noticed you need to remove the whole bracket in order to remove the filter as the securing bolt is on the wrong side for good access, this is because the bracket was originally use...
Seal to fit between union WKB10019 and the fuel filter on injection cars.
This is a copy of one of the best looking gas caps you will ever add to you car. Polished chrome with a flare. The "'flip top' and 'push button' opening cap was made famous by some of the most historic cars ever raced at such famous tracks as 'Monz...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.