(¥1) £1.40 exc vat
(¥2) £1.68 inc vat
In stock
(¥1) £1.40 exc vat
(¥2) £1.68 inc vat
In stockRecommended usage 1 x 2A5872 to fit one mini.
The last Rover update on the upper engine stabiliser bar, but this is upgraded for performance use.
A one piece silent block type bush, it was fitted at both ends from 1996 on and will fit any cars that had 2 bushes fitted at either end as o...
The original stabiliser kit with cone shaped spacers to strengthen up the rubber bushes against engine movement. Kit includes 4 cone metal shaped inserts and 4 bushes. When stocks run out only the plastic insert type kit SBK1 will be ava...
Replacement O ring for the Minispares range of chrome dipticks
Set of 4 ignition leads from the original supplier to Unipart, suitable for all twin point minis 1997 onwards. For use with M4 type coil.
Upgraded rocker cover gasket made in silicon, ideal for race cars etc where the rocker cover is removed on a regular basis. Mini Spares fitted one on their 1380cc engine road car in August 2014 with great results. Rarely you may require longer rocker...
Original type engine lifting hook. Sold individually (2 required).
Fitted to all gold and some silver seal engine from the factory they were even found on original engines from the 1959 on era.
These are sold per bush but fitted in pairs.
Apart from very early cars all minis up to 1996 had 2 of these each end.
From 1996 rover fitted a single silent block type bush which will fit your existing 21A1109 arm (par...
All "A" Plus and engines with metal tube to locate dipstick (no 850cc or Automatics). 227mm from mount face to full mark.
A design initiated by Keith Dodd as an easier to use alternative to the other engine oil dip sticks available with butt...
If you drive A-Series cars long enough you will eventually have to replace the water pump bypass hose. These are the best quality available to fit without removing the cylinder head but these fluted rubber hoses have a bad reputation so if possible ...
These can get really cooked behind the exhaust manifold, if you're oozing oil it may be time to replace them. Sold singly 2 required per engine
Forget all the universal shape gaskets available - this is the original correct shape made out of thick gasket paper.
Universal crank case breather with chrome top and a 13mm(1/2")neck size.
2"wide top (50mm) and 35mm high
The special washer under the tappet cover bolt.Sold singly 2 required per engine.
See 12A1176 for seal
Lower Stabilizer Kit, LH.
Designed as an almost mandatory addition to any Mini with a rod change transmission, extra stabilizers will greatly aid any car. In standard form the engine control is left to the upper stabilizer. This often result...
Ribbed fins on a slant similar to MG Metro original equipment.This is the traditional dress-up for the engine compartment! Great looking, easy to clean and helps cool engine oil. Red plastic Cap is included, but is not the original colour red, we can...
These 1/4"UNF 3/8" long bolts were used on the one piece cowling from 1974 on. Many people have punctured their radiator by using too long a screw. Also used as the small timing cover bolt on A series engines. Also the small bolt on the front wheel c...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.