(¥20) £19.65 exc vat
(¥24) £23.58 inc vat
In stock
(¥20) £19.65 exc vat
(¥24) £23.58 inc vat
In stockRecommended usage 2 x M16006 to fit one mini.
Stainless steel clip on overtaking mirror. This clips to the seam moulding on the UK drivers side only. Mirror size is 73mm x 103mm
Original Tex long straight arm, see also M16008 long curved arm. Height form mounting face is 85mm.
All early mini vans and saloons used a straight angled arm, this is the only arm available close to this shape,vans were black w...
Mini Spares/Tex stainless steel/chrome door mirror from Tex were fitted to production minis from 1970 to 1980. These large 3" x 5.5" mirrors have also been used on many later models of the Mini, they look good and allow you to look great (rearwards) ...
Original Tex short arm most commonly fitted to minis with larger oblong mirrors.
Hieght from mounting face is 70mm.
Mini Spares/Tex stainless steel/chrome door mirrors from Tex were fitted to production minis from 1970 to 1980. These large 3"x5.5" mirrors have also been used on many later models of the Mini, they look good and allow you to look great (rearwards.) ...
The original type flat glass round chtome mirror by Tex fitted to early minis.
The vans had black which is obsolete. the chrome securing nut is supplied with the arm M16009 etc
Original tex chrome mirror arm,see also M16009 long straight arm.
some of these oval mirrors were fitted to cars in the 60s and 70s by dealers when the cars came from the factory without any mirrors at all.
some of these oval mirrors were fitted to cars in the 60s and 70s by dealers when the cars came from the factory without any mirrors at all.
The rubber sucker that sits on one prong of the internal mirror to secure it against the windscreen to stop vibration and movement. Fitted from 1965 until design change in 1996. A black sucker 24A1535 was fitted on a twin ball stem from ...
The interior rear view mirror in the Mini is the most often used in the car, it is also very visible from the outside. The three screw that hold them in place are almost universal regarless of the year of the car. The MK2 mirror only differs in size ...
The gasket that sits behind the door stiker on all wind up window type minis
on the B post.
MK3 Door & boot handle fitting kit, including original type screws, star washers and gaskets.
Complete fitting kit for the door check straps on all Minis fitted with external hinges.
Wiper mounting kit for Mk1 Mini's (3 required per car). Each kit comes with a pin, nut, 2 washers and mounting rubber.
Genuine Mini Spares product. The seal that goes on the neck of petrol tanks as protection against water intrusion and to also to make the hole look neater, so replace them when they crack or shrink through heat. This is the original fatter type as us...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.