CENTRE SPEEDO HOUSING BRACKET KIT
24A53KIT

($16.00) £16.00 exc vat

($19.20) £19.20 inc vat

In stockIn stock
Brackets and fittings to mount the MK1 speedo housing.

($16.00) £16.00 exc vat

($19.20) £19.20 inc vat

In stockIn stock

Recommended usage 1 x 24A53KIT to fit one mini.

People also bought products

This is the ‘off white’ plastic speedo housing fitted to all models from 1960 onwards.



It is an exact replacement for the cardboard type fitted to earlier cars.

Special clip for the lower brightwork moulding 14A8009 for finishing off the lower dash, crash pad rail, or on earlier cars the painted metal surface of the panel which holds the switch panel section.

The moulding 14A80...

Small details can make a big difference to a restoration. New covers for the defroster vents won't make your car run better, they probably won't even make the defroster work any better, but they sure look better. These come in flat black primer, read...

Dash liners without air vents for either side of the speedo on deluxe versions such as the Cooper S with centre speedo and two gauges which are black vinyl covered as opposed to the painted type. Not for the single centre clock only.

see [li...

plastic heater knob that pushes on the end of the control lever on Mk1/2 heaters. one required per car.

Black door pocket liner for the R/H door which has sliding windows and external hinges

Black door pocket liner for the L/H door which has sliding windows and external hinges

Multi purpose square plastic plug/nut for No8 screw size was used on many door fixings and fuse box to body.



Also suitable for Twin Point indicator fixings.

Oil gauge adaptor for fitting into engine block or T piece.

Reproduction gear lever gaiter for all remote control type gearboxes with the short gear lever by the driver's seat. The metal retainer for this gaiter is 14A9942. These were fitted until the introduction of the rod change type [link]CZH...

The special pointed shape buffer locates against the boot board of Cooper S and variants where a factory type boot board is fitted.

IGNITION BARREL TO FIT 13H337 SWITCH. MK1/2/EARLY MK3. ONE BARREL,TWO KEYS

If you have twin original 5.5 gallon tanks this 26" wide boot board is the one for you.

Also used for other trim areas this clip holds the vinyl or fabric of the seat covers to the metal framework.This part has larger D shape and claw spikes but if you want the smaller D shape and claws for headlining and rear seat covers see[link]14A80...

Front Ashtray with Solid top as used in the top dash rail when vinyl covered, from 1961-71, Most deluxe and Cooper variants. See 8D2490 for fluted ash tray as fitted to painted top dash rail 1959-85

These alloy/aluminium 'polka-dot' kick strip plates were originally fitted to the MKI Mini to protect the door seals and to hold them against the body.

The lower brightwork moulding for finishing off the lower dash, crash pad rail or on earlier cars the painted metal surface of the panel which holds the switch panel section.See 14A8010 for clip

This moulding was fitted to all m...

The rubber sucker that sits on one prong of the internal mirror to secure it against the windscreen to stop vibration and movement. Fitted from 1965 until design change in 1996. A black sucker 24A1535 was fitted on a twin ball stem from ...