£7.43 exc vat
£8.92 inc vat
In stock
£7.43 exc vat
£8.92 inc vat
In stockRecommended usage 1 x OA to fit one mini.
A must if you want to run a mechanical oil gauge and retain the oil warning switch. Screws straight into the block on all A series engines.
Oil pipe in plastic 5 feet long, if fitting to a Tim gauge you will require LMA017 adaptor for the gauge.
Not comppatable with the CAM6431 standard oli pressure block union, and OA shoudl be purchased to fit.
With this large diameter line to the oil pressure guage you can actually see minor fluctuations in the pressure at idle or when the relief valve bounces open and closed. Because the braided steel line is one piece from the block to the gauge there is...
Angled oil pipe adaptor for fitting in confined spaces to eradicate damage of oil pipe, requires an OA adaptor if being used with a oil pressure gauge/t-piece.
Oil pipe in plastic 5 feet long, if fitting to a Tim gauge you will require LMA017 adaptor for the gauge.
Not comppatable with the CAM6431 standard oli pressure block union, and OA shoudl be purchased to fit.
29" long for L/H/D cars from about 1988 on when Seiko nippon speedo gauges are fitted. earlier cars used a 33" cable GSD102 which had the grey end but are interchangable and cheaper.
A heavy duty type of speedo cable which is used on our mechanical tachometer kit C-STR1058
A must if you want to run a mechanical oil gauge and retain the oil warning switch. Screws straight into the block on all A series engines.
Speedometer cable, 30" long for Smiths type central speedo-original was 26" long
Mini Moke Speedo Cable for the Centre clock type speedo,also 13" longer to allow the Smiths type central speedo to be moved.
If you have an early Mini saloon or Estate/Van or Pickup with the fuel tank sending unit held in by screws, this is the correct screw for you.
Do not forget the special copper washers also 2A2088 and the cork gasket [link]2H10...
You will need this union for your Tim gauge if you fit a replacement plastic oil pipe part number OL
Extra long cable for Smiths central located speedo when position moved in dash and also used as a Tacho cable for Sprite, 36" long.
48" extra long speedo cable for special fitmentswhen using original type Smiths central mounted speedo.
2.2 WATTS and fits back of gauges in cars with 3 extra 52mm round clocks.
This is the wiring short conversion loom that fits to the old central speedo and is used by people modifying from 2 or 3 clock dashes to single clock or just repairing damaged looms. With the correct bulb holders and spade fittings. Now uses 5x [link...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.