MECHANICAL TACHOMETER CABLE
CAB4

£24.75 exc vat

£29.70 inc vat

In stockIn stock
A heavy duty type of speedo cable which is used on our mechanical tachometer kit C-STR1058

£24.75 exc vat

£29.70 inc vat

In stockIn stock

Recommended usage 1 x CAB4 to fit one mini.

Kit products

Mechanical tachometer kit. The ultimate in rev counters; driven directly from the end of the camshaft this is the most accurate indicator of engine speed; it doesn't suffer variations caused by electronic components or needle damping employed in elec...

People also bought products

Sealing washer for the oil gauge to oil pipe as sold in OL kit and for 21A804 metal pipe to oil gauge.

With this large diameter line to the oil pressure guage you can actually see minor fluctuations in the pressure at idle or when the relief valve bounces open and closed. Because the braided steel line is one piece from the block to the gauge there is...

Oil gauge adaptor for fitting into engine block or T piece.

A must if you want to run a mechanical oil gauge and retain the oil warning switch. Screws straight into the block on all A series engines.

This is the wiring short conversion loom that fits to the old central speedo and is used by people modifying from 2 or 3 clock dashes to single clock or just repairing damaged looms. With the correct bulb holders and spade fittings. Now uses 5x [link...

This is the original type of metal pipe that fitted from the engine to the

hose on cars with central speedo and gauges. The pipe that went from the rubber hose to the gauge was 21A804. The hose is FAM2807.

...

Standard replacement cable for central located Smiths Mini speedometer.

Oil pressure is the "blood pressure" of your engine! Know how it is doing and you know how your engine is doing. This Smith's gauge is the standard 2" diameter with chrome bezel. Mechanical.

Does not come with pipework,bulb holder or bulb.

Electric water gauge as standard on the centre binnacle Mini. Marked "C-N-H" Genuine Smiths. For post 1964 vehicles with voltage stabiliser fitted on speedo.

The early type had 3 connector tabs on one long brass strip for wires where as thi...

This is the oblong metal box attached to the rear of your round centre speed heads to stabilize voltage to the fuel gauge. For Centre clock Speedo only!

made for negative earth only--BR1310

If you are serious about your driving then you want to understand how your engine is responding to your urges. Many types of tachs are available in the aftermarket but since we drive British it should say "Smith's"! Available in either 8,000 (RVC10...