($0.20) £0.20 exc vat
($0.24) £0.24 inc vat
In stock
($0.20) £0.20 exc vat
($0.24) £0.24 inc vat
In stockRecommended usage 1 x DJP8801 to fit one mini.
Used on the following circuits: Headlight main and dipped beam, sidelights, alarm and instruments, rear foglight, headlight levelling, ignition auxiliaries, radio, airbag ECU, brake test switch warning light, indicators, clock, hazard warning lights,...
Used on the following circuits: Heater blower motor, driving light relay, sunroof motor, wipers/washers, radiator cooling fan, indicators, stop-lights, reversing lights, heated rear window and front foglight relay.
30 amp maximum fuse for the engine fusebox and management link under the bonnet.
blade or double spade type fuse
Maxi fuse located in the engine bay fusebox on all post 1997 mpi cars, 30amp.
Maxi fuse located in the engine bay fusebox on all post 1997 mpi cars, 30amp.
Inline fuse holder with approximately 7" of wire to replace the old original holders located under the scuttle panel which corrode over time.
30 amp maximum fuse for the engine fusebox and management link under the bonnet.
blade or double spade type fuse
Used on the following circuits: Heater blower motor, driving light relay, sunroof motor, wipers/washers, radiator cooling fan, indicators, stop-lights, reversing lights, heated rear window and front foglight relay.
Used on the following circuits: Headlight main and dipped beam, sidelights, alarm and instruments, rear foglight, headlight levelling, ignition auxiliaries, radio, airbag ECU, brake test switch warning light, indicators, clock, hazard warning lights,...
This is the latest model fuse box as used on all Minis after 1976 and all MG Midget/Sprites with 1275cc. Simple and easy to replace or upgrade from the earlier version. This box has the added advantage of having 4 fuses in place of the earlier vers...
This later type oblong fuse box cover was fitted to the box that held 4 fuses as opposed to two and was fitted from 1976-1996.
Complete fuse box less fuses is RTC440A.
Fuse Box-Pre 1976
Early style twin fuse box as used on many cars and models. If your box is corroded, as most are, then the "Price of Darkness" is bound to strike you.
This is the 'later' early model with blade connectors and comes...
Replacement fuse. 35 amp was standard for the light circuit and the 'all other' circuit, too, on early cars with the two circuit fuse box.
If you don't remember where your spares are, or you've used them up, you may want to replenish you...
Battery cut-off switch. FIA approved
Most race sanctioning bodies require the use of this special (diode protection device) cut out allowing the switching off whilst the engine is running without damaging the electrics. The switch has to be ...
Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls
Set of 4 ignition leads from the original supplier to Unipart, suitable for all twin point minis 1997 onwards. For use with M4 type coil.
Range of distributors with modern day curves specially built,programmed and tested for Mini Spares in UK.
Beware of the cheap China made units that we have tested and currently offered by other vendors that are poorly made with wrong setting...
Gasket/seal for all 1997 on mpi headlamp bowls (self levelling type).
This is the bracket that bolts to the front of the mpi blocks to hold the more modern type coil pack. The original type is no longer available so we had this made in stainless steel.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.