($143.25) £143.25 exc vat
($171.90) £171.90 inc vat
In stock
($143.25) £143.25 exc vat
($171.90) £171.90 inc vat
In stockRecommended usage 1 x MSA0300 to fit one mini.
Wooden 3 clock dashboard, with carbon fibre finish.
Complete car set of roof lining rods, comprising of 1 Red, 2 White, 1 Black, 1 Blue and 1 Yellow
number 1 with red ends is EEB100060
number 2 and 3 is white ends are both EEB100070
number 4 with black ends is EEB100080
...
Wooden 3 clock dashboard, with carbon fibre finish.
Full carpet boot liner kit, completely lines the inside of the boot area.
Not suitable for MPI minis.
Printed circuit board for pre 1989 cars with Smith's type 3 clock gauge clusters. These have been unavailable for many years but have now been remade exclusively for Minispares.
Wooden 3 clock dashboard + 3 extra gauge holes cut out, with carbon fibre finish for LHD cars.
Wooden 3 clock dashboard, with carbon fibre finish for LHD cars.
Works Dash for RHD cars.
The later type more common dashes as used on the classic works Monte Minis and rally cars from ST Abingdon. Often seen in car magazines and competetion rally books.
Attaches to top and bottom parcel shelf r...
Metal plate switch carrier for 5 square type switches.
127cm long and 43cm wide this is enough leather cloth trim that fitted S and deluxe models on the upper and lower facia plus the winscreen A posts. Fitting instructions are included but no glue.
Original Autin emblem stick on logo for use on gearlever knobs and key fobs sold by us. About 27.4mm wide.
Original BMC stick on logo for use on gearlever knobs and key fobs sold by us.
about 27.4mm wide
MK1/2 style pattern door and rear quarter black vinyl trim kit for MK3 on
These are the 4 major parts that can give your car a fresh look- only fits wind up window type doors as fitted to MK3 range mid 1973 on , without ash tray facility in...
Vinyl covered 9 piece black interior trim kit
This kit is for wind up window type doors,for MK3 saloons 1973 onwards (except Cooper S) and contains 2 door trims,2 rear quarter trims,rear parcel shelf,2 rear glove box trims and 2 rear wheel a...
Metal chromed old type classic handle revived for use on MG variants and then a fashion item on minis. On later cars CMZ312 screw might be required which has a smaller diameter head and longer thread. Length 90mm.
2 outer rings and 2 inner knobs which have to be stuck on.
Seal for door handles MK1/2 and all sliding window exterior hinge cars.
also used on 14A7195 mk1 boot handlle used on mk1/mk2 and van/estate
is oval shaped
for boot / rear door use the hole at the rear ...
Union Jack stick on logo for use on gearlever knobs and key fobs sold by us.
About 27.4mm wide.
Chromed version of the standard demist vent on early cars where the ashtray is
mounted in the top and middle of the metal facia. Not for later cars with large
padded windscreen rails and ashtray in the front such as Mini Clubman and...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.