£71.87 exc vat
£86.24 inc vat
In stock
Midget, MGB and of course Cooper S models to pass emissions control tests. A properly operating valve has no adverse effect on performance, but may improve it.
This is the ;ater type with the flat lid as fitted from 1966 on but fits all.
The rubber diaphragm is available as 27H7758.the bracket to hold it was AEG351 which is nla
£71.87 exc vat
£86.24 inc vat
In stockRecommended usage 1 x 13H5191 to fit one mini.
The rubber diaphragm that sits in the exhaust emission valve.known as the clacker valve on Cooper S and some variants/It sat on the inlet manifold and a clip holds the top on to where this rubber sits, This diaphragm is not suitable for the raised li...
This is the original type of needle valve that governs the plastic fuel float in your SU carb.
An alternative better upgraded version is available as CA90.
Linkage set for Converting from waxstat to standard type jet for one single carb .
For 21A2331 pipe. Before the days of Aeroquip, Minis had braided petrol pipes. They should be used in place of rubber for all fuel lines where possible. This is 5/16" bore size for the joining pipe on twin tanks using the original pipe ...
Fuel or water T piece adaptor
used when upgrading fuel system size on specials from 1/4" to 5/16" or any other modifications
This tool/gadget allows you to balance both air intakes on either twin SU or twin choke carbs so they flow exactly the same to give better performance and economy.
spindle and fixings only for the HS2 carb-the butterfly for this is WZX1320.
sorry folks but buying both kits you get double the gaskets
The little spring that sits at the end of a spring loaded carb needle on late HS and all HIF carbs where applicable.
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
This is...
Special rubber hose 1/4" bore for use on petrol lines, this is in black and not armour plated outside but does have internal reinforcing. Supplied as pre cut 1m length with 2 clips and is safe to use with modern fuels with higher ethanol content. SAE...
Twin carb HS2 (1.25")black heatshields with link bar and 3 new return springs.
This is the original type of needle valve that governs the plastic fuel float in your SU carb.
An alternative better upgraded version is available as CA90.
Our heavy duty throttle cable is superior in many ways.
A nylon interior ensures smooth operation. The outer cable is 32mm longer and inner is 95mm longer than the standard one.
Cable to carb bolt is ACC5062.
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orang...
Master carb rebuild kit
Twin 1 1/4" SU carbs were stock on Cooper S and most Spridgets and are popular upgrades on many cars. The reason they are so popular is that the design is fantastic- but let's face it people; everything wears out and...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.