£149.10 exc vat
£178.92 inc vat
In stock
For the pick up we keep the rear lamp panel 14A7558and top capping corner repair section 14A7558CAP
£149.10 exc vat
£178.92 inc vat
In stockRecommended usage 1 x 14A7556MS to fit one mini.
Non Genuine L/H lamp capping repair panel for the Mini Pick-Up.
The rear lamp panel is also available as 14A7558
Non Genuine L/H lamp repair panel for rear corner panel on the Mini Pick-Up.
The top rear capping panel is also available as 14A7558CAP
Non genuine MK1/2 full floor pan less x member, front to rear with inner sills only --For van/estate see 24A604
This floor is 4 vent sill with round tunnel only for the MK1/2 but you will have to cut and shape the gear lever hol...
Non Genuine L/H lamp repair panel for rear corner panel on the Mini Pick-Up.
The top rear capping panel is also available as 14A7558CAP
Non Genuine R/H lamp capping repair panel for the Mini Pick-Up.
The rear lamp panel is also available as 14A7557
Non Genuine L/H lamp capping repair panel for the Mini Pick-Up.
The rear lamp panel is also available as 14A7558
Non Genuine R/H lamp repair panel for rear corner panel on the Mini Pick-Up.
The top rear capping panel is also available as 14A7557CAP
Although this panel is non genuine it is the most accurate for MK1 Cooper S restorations as it has the correct number plate brackets and slam panel.
If you have a pre 1964 car with the one piece valance with no cooling cut outs for brakes ...
Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.
Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.
Non Genuine reproduction tank fits all the long wheel base Minis, except for the very early side-tank travellers. Also used on many kit cars and specials owing to its shape.
Because of the outside location of these tanks, the originals seem ...
The last type of rod change rib design floor made for the assembly line fits cars from 1997-2000. It has a large rib down the centre of the L/H side.
This floor produced from genuine tools has the crossmember fitted with the sill panels an...
Front subframe fitting kit for pre 76 twin bolt subframes, locktabs are included but not the subframe tower spacers as these rarely need changing.
Complete set of bolts to mount the front subframe on all post 76 single bolt subframes less the large tower bolts and towing eye, enough fixings are supplied for those who wish not to use a towing eye.
Angled spacer washer for Mk1/2 external door hinge cars for the upper hinge
Van R/H full length half floor. You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width and length -plain pressed floor with indents but no carpet brackets or lugs underneath.
Van L/H full length half floor. You can spend hours cutting out rust and patching holes, but why bother? These reproduction floor pans extend the full width and length-plain pressed floor with indents but no carpet brackets or lugs underneath
non genuine L/H outer MK3 door skin lower few inches repair section.
not as good a fit or looking as the genuine complete skinCZH3301
non genuine R/H outer MK3 door skin lower few inches repair section.
not as good a fit or looking as the genuine complete skin CZH3301
part inner wing R/H from Damper bracket mounting points forward MK1 except Clubman. 1959-69 it has no air hole in side-see CZH3064 for later type with hose hole.
NON genuine panel
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.