Angled spacer washer for Mk1/2 external door hinge cars for the upper hinge

Genuine Mini Spares product. The seal that goes on the neck of petrol tanks as protection against water intrusion and to also to make the hole look neater, so replace them when they crack or shrink through heat. This is the original fatter type as us...

Called the rear bonnet seal it actually sits in the windscreen front scuttle panel on all minis up to 1991. This is the shape and size neoprene foam seal that we have found works best and has an adhesive backing to make fitting easier and less messy.

Minispares 2 piece plastic roof moulding kit specially shaped for the corners and drain holes as fitted from 1980on in black.

The 2 joining and finishing clips are DBE10006PMD which need to be ordered seperately. The last Rover...

The scrivet for holding the front of the rear wheel Sportspack arch and the rear of the front arch. Rover also used rivet RY612535 as an alternative.

Non Genuine for the Pick-up and Van 1964-75 with a slat type fixed grille as a trademark for Mini commercial type vehicles originality.

This panel has the brake cooling cut outs on corners.

Earlier models 1961-64 had no cooling cut...

This is the only hinge available for your pick up tailgate as the factory stopped making them before the millennium. Not genuine but a very good replacement when beggars cannot be choosers.

Non genuine wheel arch L/H

This genuine tank from original tooling fits all the long wheel base Minis, except for the very early side-tank wagon. Because of the outside location of these tanks, below the rear cargo area, they seem to take a real beating and should be checked f...