£26.43 exc vat
£31.72 inc vat
Special order
£26.43 exc vat
£31.72 inc vat
Special orderRecommended usage 1 x AUD9149 to fit one mini.
Linkage set for Converting from waxstat to standard type jet for one single carb .
Not fitted as standard to the A seriers it found its way on engines as a great tuning aid on tuned engines. this is the spindle only and the disc is WZX1321.We suggest you use a complete rebuild kit if this area has worn-CRK223 which will have to be ...
spindle and fixings only for the HS2 carb-the butterfly for this is WZX1320.
sorry folks but buying both kits you get double the gaskets
Our heavy duty throttle cable is superior in many ways.
A nylon interior ensures smooth operation. The outer cable is 32mm longer and inner is 95mm longer than the standard one.
Cable to carb bolt is ACC5062.
Throttle return springs for all twin carb variants. Usually 3 fitted.
Complete with screw the choke trunnion is used on nearly all SU carb linkages.
See ACC5062 for carb cable link trunnion also.
Manifold to carb gasket for HS2 single and twin carbs, usually 3 per carb required.
Float grommet for the mini twin HS2/4 carbs---this 30 degree angle is for the L/H ( front) carb and is positioned to angle the float bowl--Used on both twin HS2/4 carbswhen using correct mini inlet manifolds- Midgets and MGB used different angles,u...
Locating rings originally made for 12G295 heads with twin carbs to line up the inlet manifold to the inlet ports on the cylinder head it found its way on most twin carb factory produced cars. There is a recess in the inlet port on the he...
This throttle return spring fitted every HS2/4 single SU carb and also on the twins as fitted by the factory. Twin carbs used AEC2075 for choke return. Total length 90mm.
Float grommet for the mini twin HS2/4 carbs---this 30 degree angle is for the R/H ( rear) carb and is positioned to angle the float bowl--Used on both twin HS2/4 carbswhen using correct mini inlet manifolds-Midgets and MGB used different angles,usual...
The proper slot head screw for the SU dashpot and float lid 3/16 whitworth thread.
Accelerator bracket for twin carb models, mounts to inlet manifold.
Spacer with gaskets fitted for any 4 bolt fitting carb such as HS6 HIF range about 9/16" (14.5mm). As this is the only thick spacer you need to check stud length.
This fitting kit suits all later day 1.25" and 1.5" twin carb set ups where the balance rods between the carbs required are equal length (2.25"), some early carbs had the balance bar with a triangular plate that were a shorter length. The kit has the...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.