£445.83 exc vat
£535.00 inc vat
In stock
these are the longer type for fitting weber carbs to the 8 port head but will require severe body modifications. they are however the answer to the best power available except injection. Please note these wi...
£445.83 exc vat
£535.00 inc vat
In stockRecommended usage 1 x C-AHT507 to fit one mini.
8 port large bore exhaust manifold to compliment our race 8 port head
Small hose clip for 1/4" fuel line (our part number PETROLPIPE)
Standard bore LCB (1-3/4"id) that is ideal for very hot small bore engines, for standard to high performance 1275s and for street 1380s.
There is NOT enough clearance room when fitting to old cars with rubber couplings which foul. Using [lin...
Probably the most changed stud on the mini. This is the length used on every A series engine until the introduction of the sandwich plate when longer ones were required. A stainless steel variety C-STR286 is available which we do recomme...
This throttle return spring fitted every HS2/4 single SU carb and also on the twins as fitted by the factory. Twin carbs used AEC2075 for choke return. Total length 90mm.
Accelerator bracket for twin carb models, mounts to inlet manifold.
1.75" bore single box, centre exit exhaust system. This exhaust system by Maniflow is straighter and louder than our RC40 system. Very high quality with a skid plate on the bottom of the silencer and a polished stainless tip. Suitable for use with an...
Replacement screws and nylon inserts for the Van, Estate and Pick up petrol tanks.
Points for the original style AUF214 SU electric fuel pump,if the car has not been used for a while these points often stick so you need to give the pump a few careful whacks to help them disengage. If they stick again check them over f...
Saloon petrol tank retainer clip for the rubber seal on the sender unit which is ARA1502 .Early tanks had 6 screws holding the sender unit in place and used gasket GUG705711GM
Seal for Saloon petrol tank sender unit and the retainer clip is ARA1501. Early type tanks had 6 screws holding the sender unit in place and the gasket is GUG705711GM. .
Fuel tank sender unit for saloons up from 1964 to 1992 when a voltage stabiliser was fitted.1964 built cars could have had a similar locking ring type but if no voltage stabiliser fitted on back of speedo they fitted a ARA959 which is ob...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.