£178.19 exc vat
£213.83 inc vat
In stock
£178.19 exc vat
£213.83 inc vat
In stockRecommended usage 1 x C-GRH006BLACK to fit one mini.
Spring clip for securing the top hose on MPI front mounted radiator models, now in stainless steel.
Spring clip for securing the top hose on MPI front mounted radiator models.
Silicone heater hose, 39" for cars with the inline type heater valve or a straight take off on the cylinder head as fitted to post 1988 cars.
Radiator hose kit for all mpi Minis. This kit has top and bottom radiator hoses all in shiney blue Silicone that should last forever and not degrade with heat, time and environment. This kit is ideal for both the racer who never wants a failure or th...
Radiator hose kit for all spi Minis. This kit has top and bottom radiator hoses and 2 lengths of heater hoses…all in shiney black Silicone that should last forever and not degrade with heat, time and environment. This kit is ideal for both the racer ...
Silicone heater hose, 42" for cars with the original heater valve bolted on the cylinder head.
Cars after 1976 require one of this 42" length and one C-GRH1006 39" length.
Cars from late 1984 to 1988 had 5/8" outlets on...
Silicone heater hose, 39" for cars with the original heater valve bolted on the cylinder head.
Pre 1976 cars can use 2 0f these lengths, commonly known as 1/2" bore heater hose. also see C-GRH1007 for the longer 42" hose on 1976...
Water pump fitting kit for models without bypass facility, includes new bolts, washers and superseal gasket.
5/8" straight connector piece for heater hose modifications on late minis.
Useful when re-routing hoses or joing hoses.
Water hose pipe clip for the GRH1140 top hose and twin point injection cars which had larger hoses fitted .This clip will wind down to fit most radiator hoses if required.
Special thin type clip for fitting the water by pass hose between the water pump and the cylinder head. Most ordinary jubilee clips will not fit the tight area where the hose fits. Also used on C-AHH8537 oil cooler hose.
If you drive A-Series cars long enough you will eventually have to replace the water pump bypass hose. These are the best quality available to fit without removing the cylinder head but these fluted rubber hoses have a bad reputation so if possible ...
Hose clip for 5/8" heater hose and used to locate 3/4" diameter anti roll bar in our C-AJJ4008 kit.
Clear plastic windscreen washer tubing sold by the metre only. This is the larger size and was known as 1/4" bore because GWW201M is 1/8" bore. This hose is actually now known as 4.8mm which is nearer 3/16".
this was known as 1/...
In 1974 the mini changed from a two piece to a one piece cowling. These bolts ONLY fit the two piece pre 1974 cowling.
Upper radiator hose for 850/998/1098cc Mini Mk2. This hose is shorter than the original Mk1 radiator, but fits all curent radiators where the radiator outlet is positioned 1-1.5" in from the outer edge.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.