£9.00 exc vat
£10.80 inc vat
In stock
6.5"-6.75" Long
17H6298 single gaiter 4.5" long.
BHM7113 gaiter kit 4.5" long.
GRG205 gaiter kit 4.5" long, Genuine.Now obsolete
GSV1004 gaiter kit with 2 diameters 6.5" long, most Quinton Hazel and many quickracks.
GSV1056 gaiter kit 7.5" long.
£9.00 exc vat
£10.80 inc vat
In stockRecommended usage 1 x GSV1004 to fit one mini.
Set of 4 High quality Japanese sealed ball joints.
Developed and tested over a period of three years, the original concept was to manufacture a high quality product, similar to those used on modern vehicles. Unlike the current des...
Mini steering racking fitting kit comprising of 2 U-bolts, 4 nyloc nuts, 2 plastic anti friction stipes, the foam rack to body seal and the half nuts to lock the track rod ends
Screw for MK4 (1976) onwards BHM7085 plastic steering cowl, 2 required. Sold singly.
Nylon bush for original C.A.M steering racks fitted by Leyland/Rover.
For all MK4 minis from 1976 until 1996 air bag models arrived.
Models from 1989 on only have one cancelling pin,match the boss to the existing wheel and remove unwanted pin.
Required to fit Mountney wheels to your Mini. The Mkl adapter Black boss has a built-in horn-push. The Mkll (BOSS/V3) is for cars with the horn on the stalk.
Special shaped U bolt for holding the steering rack in place. Every mini uses 2 of these and make sure you fit the 21A2553 plastic anti friction strips. Sold singly
The sponge dust shield that fits over the splined area of the steering rack as it bolts up against the bulk head. Usually it is sold with the centre part cut but not pushed out, but it pops out easily and is shown on our picture as a reference only. ...
Quickracks-If you are interested in performance driving then you know reaction time from the driver to the car is critical; the time it takes to turn the steering wheel to the desired angle is important! The standard rack is 2.7 turns lock to lock, o...
A bit larger than the MK1 to accept the improved indicator switch this fitted
MK2 and MK3 cars until the introduction of the steering locks.
Upgraded thicker steering arm as fitted to Cooper S MK2/3 and 1275GT. The Mini MK2 Steering arms were designed to be used with the later model rack that has a tighter turning ratio than the early MK1 rack. The angle of these arms is slightly differen...
Bolt for the bottom of the inner steering column to lock it onto the steering rack spline. This is a Rover special fitting bolt with a 1/2" plain shank to fit the inner steering column groove.
As it is an expensive bolt, for any other purpos...
Longer track rod end for running with negative camber, gives an extra 5mm of adjustment approximately over the standard item. Has consistent thread pattern and perfect design to our requirements to fits all known racks and classed as a competition tr...
An easy way to dress up any car is with a better looking steering wheel, and a smaller diameter wheel should be considered mandatory for driving enjoyment. Most of our cars are such that the steering wheel is ofen exposed to the destruction caused by...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.