HORN TWIN SET 93MM WITH RELAY
LMA782

£24.29 exc vat

£29.15 inc vat

In stockIn stock
A working car horn is not only a necessity it is also a legal requirement in England and most other countries.This twin upgrade open trumpets is just the set you need to be heard.

£24.29 exc vat

£29.15 inc vat

In stockIn stock

Recommended usage 1 x LMA782 to fit one mini.

Alternative products

A working car horn is not only a necessity it is also a legal requirement in England and most other countries.This is going one better with air horns that have open red trumpets.

People also bought products

All the horns we sell have a bracket on them but this is the original type from Rover.

A working car horn is not only a necessity it is also a legal requirement in England and most other countries.This the single spade terminal with an open trumpet

A working car horn is not only a necessity it is also a legal requirement in England and most other countries.This is going one better with air horns that have open red trumpets.

Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.

This will replace the orange lens fitted on the wing of all cars from 1986 on, fitted with an orange LED. If you need a new loom for this lamp see AFU3358. Sold singly. Does not require a resistor.

Pop rivet for fixing the headlamp bowl to the wing. Great for MS14 metal bowl but be careful if using on plastic bowls

Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...

Small battery cable retaining bracket bolted at the front of the engine for pre engaged manual cars approx 1985 onwards.

For those very early 25D type distributors.Mini Spares version for modern fuels as fitted to our distributor range with slide on vaccum hose inlet pipe-not the very first screw in type

RESIN BASED CONDENSER as per the original Lucas type made for the 23/25D type distributor as fitted to original Cooper S or Racers who want a trusty part or where originality is required,with soldered wire connections and correctly made foot to sit ...

Electronic Distributor for any standard A+ 998cc. Negative earth only.



From 1982on 998cc were fitted with a ballast coil which means a new wire must be fitted from fusebox top left terminal where there is a large white cable to the...

Resistor for AFU3389LED and AFU3389WLED, this is needed to enable the lamps to function properly. Sold in pairs.

Coil bracket fitted to end stud of cylinder head,clutch end for coil to mount on as fitted 1969-94-MK3 on. This has been made to the original specification with the welded lug nuts rather than the cheaper method of having just plain holes to take a b...

Screw for holding PRC1230A to the number plate light body, 1970 onwards.

Plastic holder for the later flasher unit GFU2218. Needs to be mounted to the bulkhead prior to fitting the flasher unit to the holder

Interior lamp with square blunt ends. This part superseded 13H192 which originally had the black on/off switch which BMC also fitted as an alternative. Fitted from October 1964 when courtesy light switches were introduced on Cooper from body number 3...

INDICATOR LAMP WITH WHITE LENS AND LED BULBS. sold singly,2 required per car

Stainless steel screw kit for all mk2/3 lens to lamp body. Comes as a car set with six screws and six fibre washers.

The half bowl for holding original sealed beams into the headlamp bowl om minis and many other headlamps of the 60s and 70s. Sold singly 2 required per car.

Best on the market, sports coil-Not Lucas. A standard coil can only do so much, and when compression is raised (as in most high performance engines) or improper fuel mixtures occur something better is needed. This sports gold coil with proven origina...