non genuine L/H outer MK3 door skin lower few inches repair section.

not as good a fit or looking as the genuine complete skinCZH3301

Front A panel part of door frame with door stay hole for internal hinge cars right hand non gen.

With bracket for floor carpet on Estate. 97.5cm long.

Small reinforcement bracket panel between the inner and outer sill on the RH side rear. The 24A42 slinger sits underneath this bracket under the sill panel.

Upgraded L/H "A" panel for all Minis with internal hinges,1970 on.

A single wall panel has has a tendency to develop rust spots and is probably one of the most common panels replaced on the Mini.

Only available from Mini Spares th...

A post inner closing panel/siffener plate R/H-external hinge cars

Not always stocked owing to lack of demand but available to order

This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.

On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...

The rear lower side and rear corner panel for the Mini Van, Pick-up and Estate are all the same. This repair panel is intended to be spliced in to replace a most often rusted spot!

The full inner wing with wheel arch section for the mini clubman range --if you need only the first 20" approx of the inner wing see CZH3063.

The left side inner fender of the Mini Clubman should have a metal cowling to focus the air from the radiator to the wheel well. The almost sqaure cowling is spot welded to the inner fender. If you are resoting your car properly you will need to ha...