Front A panel part of door frame with door stay hole for internal hinge cars right hand non gen.

With bracket for floor carpet on Estate. 97.5cm long.

Small reinforcement bracket panel between the inner and outer sill on the RH side rear. The 24A42 slinger sits underneath this bracket under the sill panel.

Upgraded L/H "A" panel for all Minis with internal hinges,1970 on.

A single wall panel has has a tendency to develop rust spots and is probably one of the most common panels replaced on the Mini.

Only available from Mini Spares th...

A post inner closing panel/siffener plate R/H-external hinge cars

Not always stocked owing to lack of demand but available to order

This Non genuine pattern panel has the holes for windscreen wipers and jets with barely an inch of pillar.

On cars from 1992/3 on check the original windscreen drain channel as the VIN numbers were stamped above the clutch master cylinder-wi...

For vehicles with external hinges and sliding type windows this is a full inner front wing with the wheel arch panel. The panel is what that the outer A panels for the hinges attach to.This is the left hand pane wing with radiator vent slats but not ...

The full inner wing with wheel arch section for the mini clubman range --if you need only the first 20" approx of the inner wing see CZH3063.

The left side inner fender of the Mini Clubman should have a metal cowling to focus the air from the radiator to the wheel well. The almost sqaure cowling is spot welded to the inner fender. If you are resoting your car properly you will need to ha...

Non genuine L/H repair section

for wind up window type doors this is the lower 2-3" of the inner skin and the bottom of the door section that usually rusts out-includes a lip section where the outer skin flaps overlaps for fitment--new panel...