Genuine Mini Spares mouldings product as supplied to Rover.

These fit on the inside of the door as a draft excluder for the window, on all wind up window cars from 1970 on.

pair of outer door seal mouldings and fixing clips

These are the original type without the black plastic ends which were introduced on later models for safety criteria. All outside moudings are interchangable but are sided.

Genuine Mini Spares mouldings product as supplied to Rover.

R/H outer brightwork trim with the seal attached to stop water seeping down into the door frame, on all cars with wind up windows from about 1980 on, these are the later type with t...

Lower moulding clip for wind up window mouldings..4 PER SIDE required but sold singly-Fits CZH1666/7 and PAM1014/5

Also used for 24A1169 glove box moulding MK1/2.

High quality non genuine door check strap for MK3 cars with wind up window doors (use with retaining pin CLZ412). Beware there are cheap copies on the market that are poor quality and when fitted to our cars did not function correctly!

Genuine Mini Spares Mk3 window drop frame in stainless steel. Supplied with the rubber seal.

Rear screen seal for mk1 cars which had the smaller rear window 1959-1967.

Angled spacer washer for Mk1/2 external door hinge cars for the upper hinge

Door hinge shim for all wind up window cars, these are used to align the doors, 0.7mm thick and made in stainless steel, use with ALA6382 to get good door alignment. See ALA6381 for thicker rear support plate.

This screw can used to hold together the 2 halves of the disc shields on all

mini front discs. fits MK1/2 door escutcheons.

Use SE910161 and cut down to 3/8" long including head

PMZ306 was originally 3/8"long u...

Full Mk2 door handle set with 2 front door locking handles and boot handle with matching keys. Fitted from 1966 with the intoduction of the door safety escutcheon boss. This boss is available as 24A1834 and gasket 24A1835.

Regre...

Front and rear screen with chrome plastic insert.Saving nearly 15% on cost of individual partts

Twin point injection cars had a split seal system door frame seal for the front doors,the lower acting as a shield cover for the trim, fitted from chassis no BD134455 ON

Some customers have replaced it by the one piece CGA2835MS<...

Special lower seal--fitted to MPI cars from October 1996 show cars chassis no BD134455 ON

Has a lip on inner edge to hold carpet back and tidy internal trim but other than that the CGA2835MS will fit --the full set is