AMMETER 60/60 GAUGE BY TIM
TIM004

£15.87 exc vat

£19.04 inc vat

In stockIn stock
fits positivr or negative earth and 6 or 12 volt systems.0-60 grading for alternator use only

£15.87 exc vat

£19.04 inc vat

In stockIn stock

Recommended usage 1 x TIM004 to fit one mini.

Alternative products

60/60 reading ammeter gauge from Smiths with magnolia face

60/60 reading ammeter gauge from Smiths with black face and chrome outer ring

People also bought products

Battery voltmeter gauge prewarns you of any electrical or charging defects or low battery condition.

60/60 reading ammeter gauge from Smiths with black face and chrome outer ring

60/60 reading ammeter gauge from Smiths with magnolia face

Made by the original gauge maker for the mini this voltmeter has a BLACK face

with SMITHS stamped on it.52mm diameter.

Made by the original gauge maker for the mini this voltmeter has a magnolia face

with SMITHS stamped on it.

Electrical oil temperature gauge including sender. Sender is 1/8NPT fitting, comes with a variety of adaptors but you will need HPS8 a 5/8 UNF male to 1/8NPT adaptor and 2 AED172 if fitting to the sump.

Sealing washer for the oil gauge to oil pipe as sold in OL kit and for 21A804 metal pipe to oil gauge.

With this large diameter line to the oil pressure guage you can actually see minor fluctuations in the pressure at idle or when the relief valve bounces open and closed. Because the braided steel line is one piece from the block to the gauge there is...

We sell about 20 of these per year and many are used on similar models to those indicated-Main and dash loom only--No side wing indicators-indicator stalk on right-alternator-rear lamps with reverse lights-steering lock-inertia starter-centre speedo ...

Angled oil pipe adaptor for fitting in confined spaces to eradicate damage of oil pipe, requires an OA adaptor if being used with a oil pressure gauge/t-piece.

Oil pipe in plastic 5 feet long, if fitting to a Tim gauge you will require LMA017 adaptor for the gauge.

Not comppatable with the CAM6431 standard oli pressure block union, and OA shoudl be purchased to fit.

Oil gauge adaptor for fitting into engine block or T piece.

29" long for L/H/D cars from about 1988 on when Seiko nippon speedo gauges are fitted. earlier cars used a 33" cable GSD102 which had the grey end but are interchangable and cheaper.

A must if you want to run a mechanical oil gauge and retain the oil warning switch. Screws straight into the block on all A series engines.

Male to female brass spacer/adapter for mechanical water temp guage screws into head & accepts capillary tube. Required for SIB422 and SIB422MG. Also fits in MOCOT1

Speedometer cable, 30" long for Smiths type central speedo-original was 26" long

Mini Moke Speedo Cable for the Centre clock type speedo,also 13" longer to allow the Smiths type central speedo to be moved.

You will need this union for your Tim gauge if you fit a replacement plastic oil pipe part number OL

Extra long cable for Smiths central located speedo when position moved in dash and also used as a Tacho cable for Sprite, 36" long.

48" extra long speedo cable for special fitmentswhen using original type Smiths central mounted speedo.