£302.21 exc vat
£362.65 inc vat
Special order
This 13 piece kit is available in factory colours and to the exact design pattern as or...
£302.21 exc vat
£362.65 inc vat
Special orderRecommended usage 1 x TK3007N to fit one mini.
Reinforced elastomer liner for door trim made from VELVEX to prolong the life of your door cards.Die cut on press tools that make the original door cards. Each hole for door locks, window winders, door handles, speaker holes are precision cut to fit ...
Mini and Cooper S MK3 correct Mini door and rear quarter trim(4 piece kit in vinyl as per original pattern 1970 to mid 1973. 1973 is when the rear quarter panel trim shape has a cut out where the ash tray mount fitted and if you look and click on dia...
Mini and Cooper S MK3 correct door and rear quarter trim(4 piece kit) in Navy vinyl as per original design 1970-73- up to mid 1973 when the rear quarter panel trim shape has a cut out where the ash tray mount fitted. Black or Navy will fit any wind u...
Non moulded navy carpet set for vehicles pre 1973 with remote or magic wand type gear levers, you will therefore have to cut this hole out. Handbrake hole is ready cut with an over trimming gaiter (not the original rubber type) in place for tidier lo...
This light blue carpet is the correct moulded shape with insualation material attached where appropiate for that smart fit over the gearbox tunnels etc.For vehicles pre 1972 with remote or magic wand type gear levers you will therefore have to cut th...
The boards that sit on the facia tray of cars built after 1970 as a base for the vinyl cover VGA1995
Earlier cars had a full panel metal tray and do not require these support boards.
Fitted 1969-77 and 1992-96 originally and white from 1970-96 so see PAM5401BLACK and PAM5401AP. C posts trims changed with MPI or Heritage shells.
These headlinings are held in by different shape/length rods which a...
Reproduction gear lever gaiter for all remote control type gearboxes with the short gear lever by the driver's seat. The metal retainer for this gaiter is 14A9942. These were fitted until the introduction of the rod change type [link]CZH...
"Remote" gearshift boots 22A608 are readily available in aftermarket quality. Unfortunately, this metal retaining band had been unavailable from normal sources so we at Mini Spares recently took it upon ourselves to have our own manufac...
Fire retardent felt with correct cut outs for MK3 cars for the mini firewall just behind the carb and air cleaner full width of the panel see FELT860 for spray adhesive.
This kit has the tailored floor section including front wheel arches, plus the under bonnet and bulkhead areas only.
The lower brightwork moulding for finishing off the lower dash, crash pad rail or on earlier cars the painted metal surface of the panel which holds the switch panel section.See 14A8010 for clip
This moulding was fitted to all m...
Fitted for safety regulations to all MK2 minis from 1967-80 except Sweden and Canada to 1975 (not any MKI or van and pick up). Later commercial type minis did have it fitted with 3 clock speedo pod. This is a hard foam pad at the lower edge of the pa...
this panel closes off the front of the L/H rear wheel arch
This panel closes off the front of the R/H wheel arch and the heel board.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.