A low oil pressure warning light switch is available to help protect the engine. The standard one comes on at 7lb-much too late to avoid damage. This one comes on at 20lb and is adjustable up to 120lb. Please note this is now a twin terminal switch, ...
On /Off safety swith guard and press starter switch, plus one switch--See MSA343-2 and MSA344-3 for extra switches
These used to be supplied with a little bracket but it was discontinued by the factory so it now just hangs loose under the dash. But Minispares have re-introduced it as 5L433
Make your classic a little bit safer and racier with these rally type ignition switches.One of these mounted on your dash board will allow you to flick the red cover up, click the switch down and then thumb the button to kick the engine into life. Th...
This switch fits under the brake pedal on the floor. See also BMK1903A locknut for this item.
Battery cut-off switch. FIA approved
Most race sanctioning bodies require the use of this special (diode protection device) cut out allowing the switching off whilst the engine is running without damaging the electrics. The switch has to be ...
Used on Rod change gearboxes and fits on the side of the gearlever alloy housing, the locknut is to prevent the switch being screwed in to far. Use 22A1613 locknut.
Headlamp switch fits MK1/2/ earlyY MK3, Toggle type also known as bat handle type, 3 POSITION. BLADE CONNECTIONS.
MK1/2/EARLY MK3. 3 position spring loaded type. Comes with barrel.
For barrel only use part number 24G1345.
Brake light switch for pre 1976 minis with single line brake systems. Fits into banjo bolt (7H7995) located at O/S front brake hose. This switch has a tapered thread. Made by a UK company who suplied parts to Unipart.
For minis ...
circuit breaker for safety as required in motorsport
The switch has to be accessible from inside and outside the car.The external trigger should be located on the windscren scuttle panel -preferably the drivers side . It should be clearly ma...
IGNITION BARREL TO FIT 13H337 SWITCH. MK1/2/EARLY MK3. ONE BARREL,TWO KEYS
Mk1 Mini Indicator stalk green lens. Also fitted to other BMC variants such as Morris Minor. See GLB280 for the replacement bulb
If you have a floor mounted type of headlamp dip switch then this is the item you require.Mk1 Mini--sprite/midget MGB67-70,morris Minor.landrover,bentley, rolls and many more.
Correct 42watt 12 volt Indicator flasher unit for all MK1 minis easily identified by the locating tag on its end it was the longest/largest flasher ever fitted to the mini.
please note. this unit only works with NEGATIVE ...
Rear fog lamp switch with the orange illumination segment for all vehicles fitted with production fog lamps as standard. 3.1cm tall from 1976 on.
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.