Showing 201 to 220 of 601

Plastic window locks for sliding windows, metal ones are no longer available.

24A1194 = Right Front

24A1195 = Left Front

24A1196 = Right Rear

24A1197 = Left Rear

Four tailor made felt pieces to fit in the segments between the bonnet strengthening webs to allow maximum under bonnet clearance.

See FELT860 for spray adhesive. These are about 1cm thick and the original very thick sound dea...

Lower moulding clip for wind up window mouldings..4 PER SIDE required but sold singly-Fits CZH1666/7 and PAM1014/5

Also used for 24A1169 glove box moulding MK1/2.

These special hoses are for all sliding window type doors to drain the water away from the channels. The thin end of the hose slides into the bottom tube to ensure water goes out and cannot leak into the bottom of the door and the top slides over the...

Bezel for 24A2702 oval 3-gauge pod. This is the brightwork trim on the front of the plastic pod, it is held on with up to 14 whisker clips 14A9796. The clip to join the ends together for neatness is 24A472
<...

Original type MK1/2 door strap in Dark grey(darker than cumulus grey and dove grey was slightly lighter again)

Check straps matched seat colours or outer main seat colour on two tone types

ALE1221 Black

[link]1...

This is the top of the range spray glue that is used to make all our trim products. We recommend you use spray glue to fit your trim products to your car (where applicable). You can use the glue to fit underfelt and carpets to your floor pan, your fo...

The cap for GWW916 and GWW906 but also the the insert for windscreen washer bottle cap GWW952 found on GWW907 bottles 1980's early Minis.

Even if you have not just restored your car- you don't want the door to fly open uncontrolled. Not only can it damage the hinges but also the paint job.

Check straps matched seat colours or outer main seat colour on two tone types

(...

Dark grey carpet set with edge binding. Why not fit CARPET01 clip set to make the job complete. Made to fit any saloon they are perfect fit for rod change cars but pre 1973 with the little bulge on the round tunnel where floor start used...

This white square plastic lens is for the interior lamp EAM1650 fitted to minis from 1974 until 1985 when they recessed the later lamp AFU4092 into the headlining.

Horn push assembly for the Mk1 Austin Mini, Mk1 Austin Mini Cooper and Mk1 Austin Mini Cooper S.

For Morris cars, see 27H6944. This horn push assembly can also be supplied without a centre emblem, see 27H6945

This panel has mounting holes for later models facia crash panel. These holes will require blanking for true originality on earlier models without the facia pad

Plastic window locks for sliding windows, metal ones are no longer available.

24A1194 = Right Front

24A1195 = Left Front

24A1196 = Right Rear

24A1197 = Left Rear

As of 6/10/2015, this cage is no longer FIA approved but is suitable for and road cars.

Comes in Black.

If you have twin original 5.5 gallon tanks this 26" wide boot board is the one for you.

the classic looking 13" steering wheel from the 1960s and 70s with round holes in the 3 semi dished polished alloy spokes and a leather rim. For black spokes see 33SBLBH or for wooden rim see 353SPW