EMISSION VALVE for closed circuit breathing
13H5191

($71.87) £71.87 exc vat

($86.24) £86.24 inc vat

In stockIn stock
This very commonly used device has been very uncommon to find. We now have them! The valve is needed on nearly all twin carb models such as MG

Midget, MGB and of course Cooper S models to pass emissions control tests. A properly operating valve has no adverse effect on performance, but may improve it.

This is the ;ater type with the flat lid as fitted from 1966 on but fits all.

The rubber diaphragm is available as 27H7758.the bracket to hold it was AEG351 which is nla

($71.87) £71.87 exc vat

($86.24) £86.24 inc vat

In stockIn stock

Recommended usage 1 x 13H5191 to fit one mini.
Closed Circuit Breathing Components and Gasket Set - Qty 1

Alternative products
EMMISSION VALVE RUBBER DIAPHRAGM FOR 13H5191
27H7758

The rubber diaphragm that sits in the exhaust emission valve.known as the clacker valve on Cooper S and some variants/It sat on the inlet manifold and a clip holds the top on to where this rubber sits, This diaphragm is not suitable for the raised li...

($4.50) £4.50 exc vat

($5.40) £5.40 inc vat
People also bought products
VITON TIPPED FLOAT NEEDLE VALVE FOR HS CARBS
VZX1100

This is the original type of needle valve that governs the plastic fuel float in your SU carb.

An alternative better upgraded version is available as CA90.

($9.75) £9.75 exc vat

($11.70) £11.70 inc vat
CONVERSION KIT waxstat to standard jet (linkage on...
BFS701SUL

Linkage set for Converting from waxstat to standard type jet for one single carb .

($20.28) £20.28 exc vat

($24.34) £24.34 inc vat
ANCHOR TAG ON CARB
12A4

($0.66) £0.66 exc vat

($0.79) £0.79 inc vat
PETROL PIPE BRAIDED 5/16" BORE X 2.5"
21A2332

For 21A2331 pipe. Before the days of Aeroquip, Minis had braided petrol pipes. They should be used in place of rubber for all fuel lines where possible. This is 5/16" bore size for the joining pipe on twin tanks using the original pipe ...

($2.15) £2.15 exc vat

($2.58) £2.58 inc vat
T PIECE 5/16"
MTP002

Fuel or water T piece adaptor

used when upgrading fuel system size on specials from 1/4" to 5/16" or any other modifications

($4.28) £4.28 exc vat

($5.14) £5.14 inc vat
CARB BALANCER TOOL
MSA1003

This tool/gadget allows you to balance both air intakes on either twin SU or twin choke carbs so they flow exactly the same to give better performance and economy.

($28.50) £28.50 exc vat

($34.20) £34.20 inc vat
SPINDLE KIT HS4 1.5"
WZX1177

throttle spindle kit for single HS4 type carbs-.Quantity required-1 kit. -the butterfly is available seperately as WZX1323 for plain-WXZ1325 with air valve

($13.50) £13.50 exc vat

($16.20) £16.20 inc vat
CARB SPINDLE KIT 1.1/4" HS2
WZX1310

spindle and fixings only for the HS2 carb-the butterfly for this is WZX1320.

sorry folks but buying both kits you get double the gaskets

($11.70) £11.70 exc vat

($14.04) £14.04 inc vat
MANIFOLD STUD FOR TWIN HS2 INLET
CHS2614

Originally quoted as the HS2 twin carb manifold stud it is one thread longer than CHS2613 which was for single HS2 and spin on oil filter head to the block. UNC course thread for manifold or block and UNF for th...

($1.83) £1.83 exc vat

($2.20) £2.20 inc vat
CARB NEEDLE SPRING HIF and HS4
AUD3306

The little spring that sits at the end of a spring loaded carb needle on late HS and all HIF carbs where applicable.

($0.78) £0.78 exc vat

($0.94) £0.94 inc vat
22" BRAIDED PETROL PIPE 1/4" BORE
PPK7

Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.

This is...

($7.30) £7.30 exc vat

($8.76) £8.76 inc vat
PETROL PIPE HOSE 1 METRE
PETROLPIPE

Special rubber hose 1/4" bore for use on petrol lines, this is in black and not armour plated outside but does have internal reinforcing. Supplied as pre cut 1m length with 2 clips and is safe to use with modern fuels with higher ethanol content. SAE...

($3.27) £3.27 exc vat

($3.92) £3.92 inc vat
HEAT SHIELD BLACK KIT TWIN HS2
MSSK008

Twin carb HS2 (1.25")black heatshields with link bar and 3 new return springs.

($26.47) £26.47 exc vat

($31.76) £31.76 inc vat
FLOAT NEEDLE VALVE HS2/4/6 (VITON TIPPED)
WZX1100A

This is the original type of needle valve that governs the plastic fuel float in your SU carb.

An alternative better upgraded version is available as CA90.

($10.38) £10.38 exc vat

($12.46) £12.46 inc vat
ACCELERATOR CABLE NYLON SLEEVED EXTRA LONG
C-AHT85

Our heavy duty throttle cable is superior in many ways.

A nylon interior ensures smooth operation. The outer cable is 32mm longer and inner is 95mm longer than the standard one.

Cable to carb bolt is ACC5062.

($6.10) £6.10 exc vat

($7.32) £7.32 inc vat
10" BRAIDED PETROL PIPE 1/4" BORE
PPK4

Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.

Orang...

($4.00) £4.00 exc vat

($4.80) £4.80 inc vat
FULL HS2 TWIN REBUILD KIT
CRK101

Master carb rebuild kit

Twin 1 1/4" SU carbs were stock on Cooper S and most Spridgets and are popular upgrades on many cars. The reason they are so popular is that the design is fantastic- but let's face it people; everything wears out and...

($126.03) £126.03 exc vat

($151.24) £151.24 inc vat
CARB DASHPOT OIL FOR SU RANGE
BDR125

Correct and original thickness oil for SU carb dashpots.

($7.43) £7.43 exc vat

($8.92) £8.92 inc vat
CARB JET HS4 MINI TYPE RED
AUD9451A

Original type jet with red plastic end for HS4 carbs---If you have the later nylon coated jet see part number LZX1111A.

($12.00) £12.00 exc vat

($14.40) £14.40 inc vat
CARB FLOAT LUG 20° ANGLE L/H
AUD2677

Left hand (front) grommet to angle the float bowl at 20 degrees, sometimes found on early mini HS4 twins but all mini should have 30 degree angles. See AUD2676 for right hand (rear) . This was used on MGB HS4 an...

($10.17) £10.17 exc vat

($12.20) £12.20 inc vat