Once the old type alloy heater valve on the head was discontinued in 1990 for the plastic free floating inline type this take off union was fitted in its place on A series engine cars for use with the larger 5/8" hose. Uses 88G221 gasket...

Perfect size hose clip for all Pre Injection car radiator hoses except GRH1140 Cooper top hose which takes GHC913 which will wind down to fit all hoses also.Sold individually

Silicone hose kit for 998 vehicles from 1989 onwards that were equipped with the plastic inline heater valve, comes complete with moulded heater take off pipe and 5/8 heater pipe.

Unless you're heavily into the concours scene you'll love these hoses. These silicone hoses will withstand higher temps and pressures and will last virtually forever and if you ever had to replace a lower hose you'll appreciate that last fact. These ...

Silicone heater hose, 39")1metre) for cars with the inline type heater valve or a straight take off on the cylinder head as fitted to post 1984 cars.

3 YEAR GUARANTEE-UK made. Large impeller higher capacity water pump with a high quality die cast body. A Mini Spares procured product as the original superb Rover Airtex tooling has been scrapped.

Fitted with a PPS, glass filled plastic impe...

This thermostat housing fitting kit, suitable for all single tier thermostat housings. Comes with new studs, nuts, washers and Klinger thermostat housing gasket

Heater Matrix take off fixing kit, cars only-fits on heater matrix to take the 2 heater pipes on L/H side of car.

kit includes 2 brass take off pipes with 2 stainless steel bases and 2 water seals.

The outlet pipes are made in brass...

Long lasting silicon by pass hose between cylinder head and water pump.

These are easy to cut and slide on easier than the old conventional rubber type.

It has been made this length to fit 1275cc engine,which used the longest hose.<...

Universal stud made for fitting the HS4/HIF carb to the manifold (except HS6 with alloy spacer on cast one piece manifold which requires CHS2515 (5.8mm longer)) and it also fits the cylinder head to take the thermostat housi...

If you drive A-Series cars long enough you will eventually have to replace the water pump bypass hose. These are the best quality available to fit without removing the cylinder head but these fluted rubber hoses have a bad reputation so if possible ...

Made in Kevlar for longer life. This is the regular length 50mm long bypass hose used on all minis from 1959 except 1275cc inc Cooper S (AEG484) until the factory introduced the longer head by pass tube (12A2075) and shorter...

This gasket fits on the cylinder head for every A series heater valve or outlet pipe until the hole was no longer drilled when they changed to a heater valve fitted into the hose line from 1990 on.

Usefull joining union for 1/2" water hoses and used for oil coolers hoses.

Once the old type alloy heater valve on the head was discontinued in 1990 for the plastic free floating inline type this take off union was fitted in its place on A series engine cars for use with the larger 5/8" hose. Uses 88G221 gasket...