MK1/2 interior door handle with screw and washer.

This solid "spoon" handle is brittle and easily broken.

These are the original shape as sold under the Unipart label, not the later Rover bagged item which was a reproduction with d...

Fitted on cars up to about 1982 approximately before spring type knob on handle was introduced for safety homologation YXX3199PA.

The screw this CZA7109 handle is ZKC3317.

This 10 piece handle set is exactly the same kit as sold by every other mini specialist is in bright alloy (not polished alloy as per our other superior kit MSA1129) and consists of two of each of the following, door openers, window winders and their...

The chrome moulding to fit the door bin on all sliding type window doors, MK1/2 and all vans/pickups. See 14A6879 for early cars with lug ends held on by screws

Use the correct single sided prong clips only ADH3809 ...

door opening pair of handles in Burr walnut to compliment the wooden dashes

See also MSA0192 door pull handles, MSA0191 door cappings and MSA0194 window winder handles. Use SE910161 screw.

Black door pocket liner for the R/H door which has sliding windows and external hinges

White with mirror aftermarket sun visor for Mk3 models from 1977 -92 which were thinner than pre December 1965 for safety crash requirements. Check out the special clips to hold these visors as they are sold seperately in car sets only as [link]SV202...

Headlining kit including C post trims in cream crackle for 67-69 Minis which have a larger rear screen.

This bag is made out of "Hardura" which is a heavy PVC with a felt backing laminated to it. When sewn up it will hold the Jack & lever and is all held with the tie Straps. Because the bag is made of heavy material it will not wear through unlike plas...

The rubber type grip fitted on handbrakes-

will fit any single cable hand brake from 1976 on

Mk1/2 used 13H5541 thinner plastic type--to fit this to pre 1976 early cars you will need to put lots of sticky tape on the h...