This cushion was used on the majority of MK.I front seats.It is about 2" thick and has an extra 1" thick piece that can be glued to the front edge to give the seat cover definition and also support for your legs!

The clips that hold the seat squab vinyl to the frame on front seats and the headlining. These clips are available seperately as GHF1500.

plastic heater knob that pushes on the end of the control lever on Mk1/2 heaters. one required per car.

Special clip for the lower brightwork moulding 14A8009 for finishing off the lower dash, crash pad rail, or on earlier cars the painted metal surface of the panel which holds the switch panel section.

The moulding 14A80...

BRACKET ON FLOOR TO TAKE CARPET CLIPS

This kit contains all the brackets and mounts that were fitted on to the floor on original Coopers, Wolseley Hornet and Riley Elf with boot boards fitted as standard.

This kit does not include the bracket on the boot board 14A9783

Favourite old ashtray for MK1/2 minis with the fluted top for the rear glovebox and facia. Fitted to minis with painted top dash rail from 1959-85.

See 24A1538 also for flat lid version as fitted when top dash rail is vinyl cove...

This is the top of the range spray glue that is used to make all our trim products. We recommend you use spray glue to fit your trim products to your car (where applicable). You can use the glue to fit underfelt and carpets to your floor pan, your fo...

Lower moulding clip for wind up window mouldings..4 PER SIDE required but sold singly-Fits CZH1666/7 and PAM1014/5

Also used for 24A1169 glove box moulding MK1/2.

MK1/2/EARLY MK3. 3 position spring loaded type. Comes with barrel.

For barrel only use part number 24G1345.