(0,38 €) £0.38 exc vat
(0,46 €) £0.46 inc vat
In stock
It also fits the verto slave cylinder bracket. This is the longer bolt which goes through the spacer fitted between the DAM5992 bracket and clutch housing.
(0,38 €) £0.38 exc vat
(0,46 €) £0.46 inc vat
In stockRecommended usage 4 x SH604145 to fit one mini.
Clip to retain the speedo cable to the bulkhead on pre 82 cars approx. This clip is also used to hold the loom to the inner wing on some cars.
Re-manufactured obsolete part now available to purchase. This is an item that often gets overlooked when rebuilding the doors. It accepts the screws that retain the nylon door guide dovetail. The drain tube also passes through it. Made from steel wit...
Captive nut plate that sits behind the damper bracket on the inner wing/bulkhead to attach the damper brackets. 2 PER SIDE.
The gasket that sits behind the door stiker on all wind up window type minis
on the B post.
MK3 Door & boot handle fitting kit, including original type screws, star washers and gaskets.
Metal floor plug as per original with rubber seal.
For use in 1" hole.
Non Genuine L/H lamp repair panel for rear corner panel on the Mini Pick-Up.
The top rear capping panel is also available as 14A7558CAP
Non Genuine R/H lamp repair panel for rear corner panel on the Mini Pick-Up.
The top rear capping panel is also available as 14A7557CAP
Complete fitting kit for the door check straps on all Minis fitted with external hinges.
Non Genuine three piece verto clutch kit, has a 180mm wide clutch plate, pressure plate and release bearing,fits all cars pre 1990 VERTO assemblies until fitment of 1275cc engines. For Borg and Beck see GCK151MS
From 1990 on the...
Non Genuine 3 piece Injection Clutch with the larger 190mm wide for 1990 on and all injection cars, but it can be used on earlier non injection Verto type engines only if the flywheel is 100% PERFECT WITHOUT WEAR. Check nothing fouls when bolting up ...
Front subframe fitting kit for pre 76 twin bolt subframes, locktabs are included but not the subframe tower spacers as these rarely need changing.
Complete set of bolts to mount the front subframe on all post 76 single bolt subframes less the large tower bolts and towing eye, enough fixings are supplied for those who wish not to use a towing eye.
10" blade MK1/2 with 6 sided nut for R/H/D or L/H/D with original 6 sided nuts. Right hand park, but you will have to disgard the nuts if you seek originality as after 1970 they became 8 sided or order correct kit for later type cars MSSK0...
Early Mini runner for metal type window catches pre May 1963 with sliding windows on the L/H front doors, these are the runners that hold the channel and have holes to lock the window catches. Now made in stainless steel by Minispares to ease rust pr...
Early Mini runner for metal type window catches pre May 1963 with sliding windows on the front doors, these are the runners that hold the channel and have holes to lock the window catches. Now made in stainless steel by Minispares to ease rust proble...
Tank strap bracket welded to the rear of the boot floor which the single diagonal tank strap 21A2838 attaches to.
Angled spacer washer for Mk1/2 external door hinge cars for the upper hinge
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.