£1.28 exc vat
£1.54 inc vat
£1.28 exc vat
£1.54 inc vat
Recommended usage 3 x AEC2075 to fit one mini.
Stainless steel twin HS2 heatshields kit. Comes with link bar, bolts, nuts and springs.
Stainless steel twin HS4 heatshields kit. Comes with Link bar and springs.
Twin carb HS2 (1.25")black heatshields with link bar and 3 new return springs.
This is the original type of needle valve that governs the plastic fuel float in your SU carb.
An alternative better upgraded version is available as CA90.
Twin carb HS2 (1.25")black heatshields with link bar and 3 new return springs.
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orange ...
Clip on the heater valve for heater cables on vehicles from 1990 where the in line remote heater valve was used. It has also been used as a clip for HIF carbs to hold the cable but the one from Rover is 13H3472.
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orang...
Stainless steel twin HS4 heatshields kit. Comes with Link bar and springs.
This is the right hand linkage lever taht sits on the rods between HS type twin carbs. Sold individually
Air ducting tube from inlet manifold to air cleaner. These are 5.5" long which covers the longest but some such as the injection model is only 1.5" OR 2-2.5" long.
Manifold to carb gasket for HS2 single and twin carbs, usually 3 per carb required.
Used in petrol fuel lines to take 1/4" petrol hoses it is used mainly on twin carb set ups for petrol being diverted to the 2 carbs.
Not Built up= A Complete kit of HS4 CARBS/ MANIFOLD/LINKAGE LESS AIR CLEANER