£67.34 exc vat
£80.81 inc vat
£67.34 exc vat
£80.81 inc vat
2 reqd but sold seperately-From 1990 rover started fitting the hanging rubber exhaust mounting straps which push onto rods on the exhaust and rear subframe similar to the old metro. These were used right to the end of production on minis.
Metal gasket for the catalyst and is the same both ends for Cooper 1275CC RSP early cars, but only fitted on the front to later cars. If you cannot fit this gasket on the rear your car does not need one.
Rear RC-40 fitted with a pipe to bolt straight on to the catalyst for cars built late 1991 onwards (not early carb coopers). It has the hanger rods fited for mounting onto the rubber type straps. This makes it a single box system with a little throat...
Stainless steel tailpipe trim with hanger bracket designed for fitting to the tailpipe of RC40 rear box as an extension piece. This is part of our RC40PACKAGE015 kit for Van/Estate and Pickup exhaust system when a freeflow o...
Rear RC-40 fitted with a pipe to bolt straight on to the catalyst for cars built late 1991 onwards (not early carb coopers). It has the hanger rods fited for mounting onto the rubber type straps. This makes it a single box system with a little throat...
This short pipe fits on the end of our freeflow manifols C-STR816 to give the overall length of an LCB when you have an exhaust system to fit that was made explicitly for LCB fitment.Total length is 300mm ID is 44mm OD is 48mm.
If you wish to delete the catalyst (legal restrictions apply, so check to see if you are allowed) this pipe is specially made to replace it.
Exhaust manifold to downpipe clamp. For 32mm o/d pipe size.
The key to eliminating exhaust leaks at the manifold flange is the clamp. These cast clamps are the best style to use. A real piece of kit to use eradicating a multitude of likely p...
Adaptor to fit from Cooper Freeflow Manifold to link pipe to clear Rod change housing on Mini Mokes manufactured in Europe. 48mm bore.
1.75" Bore centre exit twin tail pipe maniflow rear box with adaptor to sleeve down to the standard mini 998cc type exhaust system.
The very rear bobbin type mounting rubber on every mini made until the introduction of a rubber hanger strap in 1992. When the RC40 or similar systems are fitted, 2 will be required. This is a stronger poly version.
Blanking plug to blank of the Lambda sensor hole on all SPI/MPI models.
M10 metric flanged bolt 35mm long for catalytic converter. (4 required per unit)