SEATBELT CENTRE MOUNTING PLATE ON REAR BULKHEAD
CZH2618

£10.50 exc vat

£12.60 inc vat

In stockIn stock
Seat belt mounting anchorage in the centre of the rear bulkhead.

£10.50 exc vat

£12.60 inc vat

In stockIn stock

Recommended usage 1 x CZH2618 to fit one mini.

People also bought products

THIS IS THE REINFORCER STRIP THAT WELDS TO THE FRONT EDGE OF THE SEAT BASE TO STOP IT BENDING

Rear handbrake bracket. 1976 onwards for single cable lever. Welds to tunnel. Not included on CZH2669 floor. For forward bracket see CZH3214.

Metal floor plug as per original with rubber seal.



For use in 1" hole.

Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.

Non genuine rear companion bin for external hinge cars. These are supplied without the ash try mount.

Body side rear lower w/arch to rear section of bodyside repair L/H. 220mm tall.

Non genuine repair panel for below the lights and above the rear valance, fits all models. Left hand side.

Genuine ashtray bracket that sits in the rear compaion bin on MK1 cars. This is LH side.

Genuine ashtray bracket that sits in the rear compaion bin on MK1 cars. This is RH side.

Rear seat belt anchor mounting point as found on later cars. This panel needs to be welded into the C post.

Rear seat belt anchor mounting point as found on later cars. This panel needs to be welded into the C post.

Non genuine rear valance closing panel with subframe mount repair



The rear valance of the Mini is a panel that is very often in need of replacing. While rear end damage can be a good reason, the most often cause is rust. The pane...

Non genuine rear valance closing panel with subframe mount repair



The rear valance of the Mini is a panel that is very often in need of replacing. While rear end damage can be a good reason, the most often cause is rust. The pane...

R/H narrow 6 flute sill for MK3 saloons to 2000 but Most/many 1970 cars and Cooper S mk3 had 4 flutes--Great quality and fitting aftermarket panel

Small reinforcement bracket panel between the inner and outer sill on the LH side rear. The 24A43 slinger sits underneath this bracket under the sill panel.

Small reinforcement bracket panel between the inner and outer sill on the RH side rear. The 24A42 slinger sits underneath this bracket under the sill panel.