PIPE FOR TURBO BOOST GAUGE
LMA001

£9.11 exc vat

£10.93 inc vat

In stockIn stock
Simply a plastic pipe for those with a turbo boost valve on Turbo engines.

£9.11 exc vat

£10.93 inc vat

In stockIn stock

Recommended usage 1 x LMA001 to fit one mini.

People also bought products

Sealing washer for the oil gauge to oil pipe as sold in OL kit and for 21A804 metal pipe to oil gauge.

With this large diameter line to the oil pressure guage you can actually see minor fluctuations in the pressure at idle or when the relief valve bounces open and closed. Because the braided steel line is one piece from the block to the gauge there is...

Angled oil pipe adaptor for fitting in confined spaces to eradicate damage of oil pipe, requires an OA adaptor if being used with a oil pressure gauge/t-piece.

Oil pipe in plastic 5 feet long, if fitting to a Tim gauge you will require LMA017 adaptor for the gauge.

Not comppatable with the CAM6431 standard oli pressure block union, and OA shoudl be purchased to fit.

Oil gauge adaptor for fitting into engine block or T piece.

29" long for L/H/D cars from about 1988 on when Seiko nippon speedo gauges are fitted. earlier cars used a 33" cable GSD102 which had the grey end but are interchangable and cheaper.

A must if you want to run a mechanical oil gauge and retain the oil warning switch. Screws straight into the block on all A series engines.

Male to female brass spacer/adapter for mechanical water temp guage screws into head & accepts capillary tube. Required for SIB422 and SIB422MG. Also fits in MOCOT1

Speedometer cable, 30" long for Smiths type central speedo-original was 26" long

You will need this union for your Tim gauge if you fit a replacement plastic oil pipe part number OL

Extra long cable for Smiths central located speedo when position moved in dash and also used as a Tacho cable for Sprite, 36" long.

48" extra long speedo cable for special fitmentswhen using original type Smiths central mounted speedo.

This is the wiring short conversion loom that fits to the old central speedo and is used by people modifying from 2 or 3 clock dashes to single clock or just repairing damaged looms. With the correct bulb holders and spade fittings. Now uses 5x [link...

This is the original type of metal pipe that fitted from the engine to the

hose on cars with central speedo and gauges. The pipe that went from the rubber hose to the gauge was 21A804. The hose is FAM2807.

...

Standard replacement cable for central located Smiths Mini speedometer.

This is the longest of the speedo cables made to fit the 2 or 3 cluster clocks mounted in front of the driver. Fitted as standard from 1976-1989 cars.

Post 1990 cars were fitted with a 42.5" cable GSD487. Early clubmans had a 3...

chrome pod for housing any of the popular size 80mm tachometers from either Smiths or Tim gauges.

tach pod in black for all the 80mm size tachoc-for chrome see SIB801

A union to fit the sump plug hole to accept Smiths oil temperature gauges, but will only take the small capillary type bulb as used on very early and current smiths oil temp gauges, does not fit the larger capillary fitted to some smiths gauges unles...