£26.09 exc vat
£31.31 inc vat
Out of stock
Has 2 vacuum pipes conected to it.
Screws into thermostat housing under top rad hose.
Use with special washer MAW10001.
Rover parts list also had it listed as MAQ10008 which was wrong.
MAQ10002 is usually stamped on the body for reference
£26.09 exc vat
£31.31 inc vat
Out of stock
Fitted in the early 1275cc carb type engines after 1990 before the injection
catalyst. Fits into the thermostat area.
Thermostat with a 10mm hole drilled in the side under the outlet flange for a sensor on 1275cc 1991-1994 carb models non Cooper.
This is the regular 12G103 thermostat housing with the part number stamped on top as fitted to many...
Main wiring grommet that fits in the front parcel shelf. ID 12.5mm fits 35mm hole.
Battery bar and fitting kit for all pre 1990 cars whcih had the shorter battery bolts.
This will replace the orange lens fitted on the wing of all cars from 1986 on, fitted with an orange LED. If you need a new loom for this lamp see AFU3358. Sold singly. Does not require a resistor.
rear stop and tail lamp for early BMc cars with red plastic lens.
Also stocked is a white lens and single filament bulb equivalent for use as reverse light on kits cars and Mokes as CHM13REVERSE.
Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...
Rear loom for 1992 on carburettor cars with a 13 way Econoseal plug.
Original 7/16" spring type hose clip as used on later cars (approx 1990 on) for some radiator hoses and fuel lines.
3 YEAR GUARANTEE-UK made.Large impeller higher capacity water pump with top quality die cast body . Mini Spares procured product as the original superb Rover Airtex tooling has been scrapped.
Fitted with a PPS, glass filled plastic impeller...
3 YEAR GUARANTEE-UK made. Large impeller higher capacity water pump with a high quality die cast body. A Mini Spares procured product as the original superb Rover Airtex tooling has been scrapped.
Fitted with a PPS, glass filled plastic impe...
Coil bracket fitted to end stud of cylinder head,clutch end for coil to mount on as fitted 1969-94-MK3 on. This has been made to the original specification with the welded lug nuts rather than the cheaper method of having just plain holes to take a b...
This is the plug that fits on the back of the front indicator lamps (XBD100670) on mpi models.
Stainless steel screw kit for all mk2/3 lens to lamp body. Comes as a car set with six screws and six fibre washers.
Best on the market, sports coil-Not Lucas. A standard coil can only do so much, and when compression is raised (as in most high performance engines) or improper fuel mixtures occur something better is needed. This sports gold coil with proven origina...
Originally fitted as standard to the MGB and MGB GT, but has the same plug configuration as the 76 on Mini's so can be used in place of the stabdard rocker switch
If you also have an issue with the plug, a new plug and wiring repair is avail...
Alloy CNC version of the cylinder head take off 12G2534. The standard item being steel can be prone to corrosion, this CNC alloy version is smart, and will not corrode like steel does
Double bullet connector used to join the front loom to the rear loom enar the wiper motor.
Auxilary wiring for genuine Rover spot and fog lamps needed when fitting genuine lamps to cars not originally fitted with auxilary lamps or for cars that have had the wiring damaged. This loom is supplied with complete lamps XBN10008 and...
Radiator hose kit for all spi Minis. This kit has top and bottom radiator hoses and 2 lengths of heater hoses…all in shiney black Silicone that should last forever and not degrade with heat, time and environment. This kit is ideal for both the racer ...
Main wiring loom with dim dip. Fits all 1275 cars with HIF38 carb from 1991-1994. No alarm.
Main and dash loom only.
Unless your're heavily into the concours scene you'll love these hoses! These silcone hoses will withstand higher temps and pressures and will last virtually forever! Made to fit 1275cc cylinder head the length is made to cover 1275cc engines includi...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.