IDLE AIR CONTROL VALVE FOR MPI 97 ON TWIN POINT IN...
MDQ100040

£76.00 exc vat

£91.20 inc vat

In stockIn stock
USE MDQ100040MSAlso known as the idle air control valve (IACV). Bolts on the side of the injection body housing to control engine idle speed and air flow from cold start up. The blue socket loom cap fits this unit. This is part of MLZ100090. After fitting the cars ignition needs to be turned on and off 3 or 4 times to allow the unit to programme itself and begin working correctly.

£76.00 exc vat

£91.20 inc vat

In stockIn stock

Recommended usage 1 x MDQ100040 to fit one mini.
Throttle Body SPI and MPI - Qty 1
Power unit electrics-MPI - Qty 1

Alternative products

Also known as stepping motor--idle air control valve (IACV)

Bolts on the side of the injection body housing to control engine idle speed

and air flow from cold start up.The blue socket loom cap fits this unit

THIS IS A MOD...

Also known as the idle air control valve (IACV). Bolts on the side of the injection body housing to control engine idle speed and air flow from cold start up. The blue socket loom cap fits this unit. This is part of MLZ100090. After fitt...

People also bought products

Genuine Bosch lambda sensor, fitted to both the twin and single point injection cars and fitted in the same exhaust manifold shared by both cars. Be warned the cheaper non branded sensors cause lots of issues hence we only sell the Bosch version.

Also known as the idle air control valve (IACV). Bolts on the side of the injection body housing to control engine idle speed and air flow from cold start up. The blue socket loom cap fits this unit. This is part of MLZ100090. After fitt...

Lots of things have been written about performance plug ignition wires but regardless of what you believe we all know that good wires are a must. This special competiton wires set from the Lucas factory has 8mm wire and the highest performance, no br...

Bolts on the side of the injection body housing to control engine idle speed and air flow from cold start up. The blue socket loom cap fits this unit. This is part of MLZ100090. After fitting the cars ignition needs to be turned on and o...

Set of 4 ignition leads from the original supplier to Unipart, suitable for all twin point minis 1997 onwards. For use with M4 type coil.

Gasket/seal for all 1997 on mpi headlamp bowls (self levelling type).

Electronic Distributor for any standard A+ 998cc. Negative earth only.



From 1982on 998cc were fitted with a ballast coil which means a new wire must be fitted from fusebox top left terminal where there is a large white cable to the...

Switch on bonnet and boot for alarm on cars from 1996 on

CSI-Ignition is a fully electronic ignition built in an original housing. You will have to remove the cap to see the difference!

After removing the cap you can select between 16 different curves by using

a screwdriver. A bright flas...

Maxi fuse located in the engine bay fusebox on all post 1997 mpi cars, 30amp.

The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank out before fitting and drive your mini more to avoid water build up.

Replacement pump only for the original WFX100810<...

The main cause of failure is water in the pump. This is caused by modern ethanol fuels. Be sure to clean the tank before fitting and drive your mini more to avoid water build up.

Replacement pump only for the WFX100810 (doesn't...

Fuel pipe from the fuel filter to engine on mpi models from chassis no WD169574 when fuel filter GFE7057 is fitted.



Tube nut has 7 threads and the metal pipe is the same size with a flared end.

This is the small plastic nut used to hold the fuel line protector shield on later cars, also used to hold the catalytic converter heat shield on, 4 required for each shield.

THE LENS FIXING SCREWS FOR THE REAR LENS ON MK4 1976 ON WITH REVERSE LENS ARE ALL THE SAME. SOLD INDIVIDUALLY. ALSO FITS TWIN POINT FRONT INDICATOR LAMP.

3 per lamp required or 6 per car set.

Gasket/seal for mounting the fuel pump to tank for SPI and MPI Mini's

Seal to fit between union WKB10019 and the fuel filter on injection cars.

30 amp maximum fuse for the engine fusebox and management link under the bonnet.

blade or double spade type fuse