The rubber that sits in the frame to hold the windows on wind up window type doors. The frames are ALA5746/7 or see MSSK2105 also used on Clubman Estate and Traveller rear windows in the finger pull grips.

Sold individually.2 pe...

Mini Spares own MK3 Window drop rail kit includes 1 x ALA5745 KIT with the 2 rails which are different front an rear (ALA5746 and 5747) plus 2 x 24A948 seals for the drop rails to hold the glass, this kit will do one complet...

Mini Spares own MK3 Window drop rail kit includes 1 x ALA5745 KIT with the 2 rails which are different front an rear (ALA5746 and 5747) plus 2 x 24A948 seals for the drop rails to hold the glass, this kit will do one complet...

The gasket that sits behind the door stiker on all wind up window type minis

on the B post.

Door hinge shim for all wind up window cars, these are used to align the doors, 0.7mm thick and made in stainless steel, use with ALA6382 to get good door alignment. See ALA6381 for thicker rear support plate.

Full Mk2 door handle set with 2 front door locking handles and boot handle with matching keys. Fitted from 1966 with the intoduction of the door safety escutcheon boss. This boss is available as 24A1834 and gasket 24A1835.

Regre...

Twin point injection cars had a split seal system door frame seal for the front doors,the lower acting as a shield cover for the trim, fitted from chassis no BD134455 ON

Some customers have replaced it by the one piece CGA2835MS<...

Special lower seal--fitted to MPI cars from October 1996 show cars chassis no BD134455 ON

Has a lip on inner edge to hold carpet back and tidy internal trim but other than that the CGA2835MS will fit --the full set is

The rubber that sits in the frame to hold the windows on wind up window type doors. The frames are ALA5746/7 or see MSSK2105 also used on Clubman Estate and Traveller rear windows in the finger pull grips.

Sold individually.2 pe...

upper door hinge l/h for wind up window type door with internal hinge 1970on

this is not a genuine part and is available in a car set kit MSSK017B

See CZH203 for genuine

Genuine Mini Spares mouldings product as supplied to Rover.

These are the later door mouldings that prevent water running down the windows into the door causing rust and have the black platic ends fitted for later car safety regulations but ...

Sponge type seal on L/H A post of all minis with wind up window type doors to protect from water running down into body. A part you must keep your eye on to stop rust.

the remote linkage for opening the door-this has the square peg in the machanism that holds the plastic inner opening handle L/Hand for wind up window type cars only