(¥533) £532.50 exc vat
(¥639) £639.00 inc vat
In stock
Choke 36
Throttle Plate Angle 78 degrees
Auxiliary Venturi 4.5
Needle Valve 200
Main Jet 145 Pump Jet 45...
(¥533) £532.50 exc vat
(¥639) £639.00 inc vat
In stockRecommended usage 1 x C-AHT143 to fit one mini.
Weber DCOE twin cable linkage set top mount.
Fits on top of single or twin DCOE installations to provide a professional throttle linkage solution.
Supplied with 2 x throttle cables and associated pedal mounting h...
Small hose clip for 1/4" fuel line (our part number PETROLPIPE)
For HIF38 carbs,this is the full rebuild kit with the spindle and throttle disc and bushes--- see CSK94 for service kit
spindle and fixings only for the HS2 carb-the butterfly for this is WZX1320.
sorry folks but buying both kits you get double the gaskets
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
This is...
This is the original type of needle valve that governs the plastic fuel float in your SU carb.
An alternative better upgraded version is available as CA90.
Our heavy duty throttle cable is superior in many ways.
A nylon interior ensures smooth operation. The outer cable is 32mm longer and inner is 95mm longer than the standard one.
Cable to carb bolt is ACC5062.
Clip on the heater valve for heater cables on vehicles from 1990 where the in line remote heater valve was used. It has also been used as a clip for HIF carbs to hold the cable but the one from Rover is 13H3472.
A very usefull tuning needle for single and twin carbs when camshaft change for carbs with floating needles.
Master carb rebuild kit
Twin 1 1/4" SU carbs were stock on Cooper S and most Spridgets and are popular upgrades on many cars. The reason they are so popular is that the design is fantastic- but let's face it people; everything wears out and...
3.5" long steel intake manifold by Maniflow for Weber 45 DCOE/DHLA.
Manifold to carb gasket for HS2 single and twin carbs, usually 3 per carb required.
Worn throttle spindles cause erratic performance from your carb and sometimes the housing gets worn--These are the bushes to repair worn carbs when replacing spindles for HS2 carbs. As a guidline 0.250" internal diameter and ream carb bo...
Locating rings originally made for 12G295 heads with twin carbs to line up the inlet manifold to the inlet ports on the cylinder head it found its way on most twin carb factory produced cars. There is a recess in the inlet port on the he...
Pin to hold the accelerator cable which locates in the carb bracket lever. Supplied as originally fitted with washers, nut and split pin plus a proper machined hole for the cable unlike many others on the market- which come either bare or with wrong ...
Contact Us| About Us| Terms| Switch to main website
Copyright @2014 Mini Spares. All rights reserved e&oe.