(¥12) £11.93 exc vat
(¥14) £14.32 inc vat
(¥12) £11.93 exc vat
(¥14) £14.32 inc vat
Recommended usage 1 x CAM4942 to fit one mini.
High quality klinger gasket that sits either side of the carb to manifold spacer on HIF44 type 1.75" carbs or HIF38. Now also sold as PKX100020EVA by Xpart
For a cheaper alternative see 88G429B sold singly.
Mini Spares own performance upgrsded paper gasket that sits either side of the carb to manifold spacer on HIF38/44 type 1.75" carbs.Sold singly, order quantity as required to suit your car.
Spacer suitable for HIF44/38 carbs, 9.5mm thick and supplied without gaskets.
picture shoen is only to illustrate use of gaskets GUG705561GM.
To convert a standard UK spec Single Point Injection car to HIF44 carb. This kit includes wiring looms,fuel tank,fuel pump, carb, air filter and inlet manifold.
Screw for holding the needle guide on HIF44, HIF38 carburettors. Also fits HS6.
This is the original type of needle valve that governs the plastic fuel float in your SU carb.
An alternative better upgraded version is available as CA90.
Twin carb HS2 (1.25")black heatshields with link bar and 3 new return springs.
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orange ...
Clip on the heater valve for heater cables on vehicles from 1990 where the in line remote heater valve was used. It has also been used as a clip for HIF carbs to hold the cable but the one from Rover is 13H3472.
Before the days of Aeroquip, Minis were fitted with braided steel rubber fuel lines. They should be used in place of rubber for all fuel lines in the engine compartment. They come made to length, with rubber end caps. 1/4" bore size.
Orang...
Stainless steel twin HS4 heatshields kit. Comes with Link bar and springs.
Throttle return springs for all twin carb variants. Usually 3 fitted.
This is the right hand linkage lever taht sits on the rods between HS type twin carbs. Sold individually
Air ducting tube from inlet manifold to air cleaner. These are 5.5" long which covers the longest but some such as the injection model is only 1.5" OR 2-2.5" long.
Manifold to carb gasket for HS2 single and twin carbs, usually 3 per carb required.
Used in petrol fuel lines to take 1/4" petrol hoses it is used mainly on twin carb set ups for petrol being diverted to the 2 carbs.